Panasonic WV-NS202 operating instructions Mail notification setup

Configure the settings relating to the mail notification [Notification]

Click the [Notification] tab on the "Alarm setup" page. (☞ page 15)

■E-mail notification setup

The settings relating to the alarm mail can be configured in this section. To provide notification of an alarm occur- rence by e-mail, it is necessary to configure the settings of the mail server. (☞ page 56)

[To E-mail server setup]

When "To E-mail server setup" is clicked, the [Mail] tab of the "Server setup" page will be displayed.

(☞ page 56)

[E-mail notification]

Select "ON" or "OFF" to determine whether or not to provide notification of an alarm occurrence by e-mail at an alarm occurrence.

Default: OFF

[Attach image]

Select "ON" or "OFF" to determine whether or not to attach an image to the mail to be sent.

Default: OFF

■E-mail notification setup

[Destination address]

Enter the destination mail address. Up to 4 destination addresses can be registered.

To provide notification by e-mail when an alarm has occurred, check the "Alarm" checkbox respective to the desired address.

To provide notification by e-mail when any of the follow- ing has occurred, check the "Diag." checkbox respective to the desired address.

•When notification of the remaining space of the SD memory card has been provided (☞ page 22)

•When the SD memory card has become full

•When mounting of the SD memory card failed

To delete the registered address, click the [DEL] button respective to the desired address.

Number of characters for the destination mail address: 3 - 128 characters

[Mail subject]

Enter the mail subject.

Number of characters for the mail subject: 0 - 50

characters

[Mail body]

Enter the mail body.

Number of characters for the mail body: 0 - 200 char-

acters

Note: Note:

The settings for "Image capture size" of the "Alarm image setup" section on the [Alarm] tab (☞ page 46) will be applied to the size of the image to be attached.

Notification mail will be sent with the following mes- sage. (The message to be sent differs depending on the status of the SD memory card.)

•"The SD memory card is full." (This message will be sent when the SD memory card becomes full.)

•"The SD memory card cannot be recognized." (This message will be sent when the SD memory card has failed to mount.)

52