1Control pad/buttons *2, 3PRESET *2 | Panasonic WV-NS202 specification

In this case, the camera will not move when the thumbnail image is clicked. (For example, when pre- set position 3 is unregistered, the thumbnail image of preset position 2 will be displayed as the thumb- nail image of preset position 3. The camera will not move when the thumbnail image of preset position 3 is clicked.)

•The camera will not always returns to the exactly same position where it was before "360° map-shot" or "Preset map-shot" was carried out. (It may some- times be slightly different.)

•The window on which the thumbnail images are dis- played will close when Clicking the following buttons that can switch the camera channel or reload images.

[Live] button, multi-screen buttons, image type but- tons ([MPEG-4]/[JPEG]), image capture size buttons ([VGA]/QVGA), full screen button, [Setup] button (☞ pages 5 - 7)

To display the thumbnail images again, carry out "360° map-shot" or "Preset map-shot" again.

!1Control pad/buttons (*2)

:Left-click on the control pad to adjust the horizontal/vertical position of the camera (panning/tilting).

Panning/tilting speed will be faster if a clicked point gets farther from the cen- ter point of the control pad.

It is also possible to pan/tilt the camera by dragging the mouse.

Zoom and focus can be adjusted by right-clicking. When an upper/lower area of the control pad is right-clicked, the displayed image will be zoomed in/out on. When a left/right area is right-clicked, the focus will be adjusted to the NEAR/FAR side.

Zoom can also be adjusted using the mouse wheel.

!2BRIGHTNESS buttons (*2)

: The displayed image will be darker.

: The adjusted brightness will return to the default brightness.

: Image will be brighter.

Note:

When the BRIGHTNESS buttons are clicked while the camera is at the preset position, the adjusted brightness will automatically be registered for the current preset position.

!3PRESET (*2)

Select a preset position from the pull-down menu and click the [GO] button. The camera will move to the selected preset position (☞ page 36). "H" next to the preset position number indicates the home posi- tion. When "Home position" is selected, the camera will move to the home position.

When the preset ID is registered for a preset posi- tion, the registered preset ID will be displayed next to the preset position number.

!4Camera title

The camera title entered for "Camera title" on the [Basic] tab will be displayed. (☞ page 19)

! Alarm occurrence indication button (*2) This button will be displayed and will blink when an

alarm has occurred. When this button is clicked, the alarm output terminal will be reset and this button will disappear. (☞ page 47)

! Full screen button

Images will be displayed on a full screen. To return to the "Live" page, press the [Esc] key or the [F5] key, or the combination of the [Alt] key and the [F4] key on the keyboard.

! One shot button

Click this button to take a picture (a still picture). The picture will be displayed on a newly opened window. When right-clicking on the displayed image, the pop- up menu will be displayed. The displayed image can be saved on the PC by selecting "Save" from the pop-up menu.

! Mic input button (*3)

Turns on/off the audio reception (hear audio from the camera on a PC). This button will be displayed only when "Mic input" or "Interactive" is selected for "Audio mode" on the setup menu. (☞ page 40)

When this button is clicked, the button will turn into

the button and audio from the camera will not be heard.

Audio volume can be adjusted (Low/Middle/High) by

moving the volume cursor .