Panasonic WV-NM100 operating instructions Bootp

SETUP

Network speed	Common to all connection	Set the network speed.
	types	Use the default setting “auto” for the network speed.
		Selectable parameters: auto (default setting), 100 Mbps (full
		duplex), 100 Mbps (half duplex), 10 Mbps (full duplex), 10 Mbps
		(half duplex)
HTTP port	Connection type 1, 2 and 3	Use the default setting “80” for the HTTP port.
	Connection type 4	If multiple cameras are connected, it is required to set up each cam-
		era individually.
		However, the port numbers already assigned to other hardware are
		not available. The following port numbers are also not available
		because this camera already uses them.
		Port number: 20, 21, 23, 25, 42, 67, 68, 69, 105, 110, 123, 161,
		162, 546, 547, 5002
Host name	Connection type 1	No setting required
	Connection type 2	Refer to your network administrator and set the designated host
		name if required.
	Connection type 3 and 4	Refer to your Internet service provider and set the designated host
		name if required.
BOOTP	Connection type 1 and 2	Set to ON when using the “Panasonic IP Setup” software.
	Connection type 3 and 4	No setting required
DHCP	Connection type 1	Set to OFF.
	Connection type 2	Set to ON if the intranet uses the DHCP.
	Connection type 3	Set to OFF.
	Connection type 4	Set to ON if the broadband router uses the DHCP.
DNS	Connection type 1	Set to OFF.

Connection type 2, 3 and 4 Set to ON when using the DNS.

Primary server Secondary server

Connection type 1 No setting required

Connection type 2, 3 and 4 Set the IP address of the DNS server when using the DNS.

Refer to your Internet service provider for the IP address of the DNS server. Primary and secondary IP addresses can be set for the DNS.

28