How to operate
If the preparations have been completed, you can begin the operation from the "Basic setup" page.
Screenshot 1
Begin the operation from the "Basic setup" page.
Screenshot 2
The "Control" page appears and the still picture of the cam- era is displayed. Operation buttons are displayed below the still picture.
Note
•If the preparations have been completed, start up the browser and display the "Top Menu" page of the desired camera. The camera picture appears on the "Top Menu" page.
•Several pictures shot during the panning/tilting may not be displayed when “Refresh interval” is set to “Very Slow”.
STEP1
Click the "Control" button.
STEP2
Operate the camera and adjust the picture.
Panning and tilting
Click the arrow buttons (up / down / right / left) to adjust the horizontal and vertical position. The center of the box surrounded by the arrow buttons (the point where the horizontal line and the vertical line cross) is the current position of the camera.
If you click inside the box surrounded by the arrow buttons, you can pan and tilt the camera wider than by clicking the arrow buttons.
Image capture size
Click one of the picture resolution buttons (VGA (640 x 480) / QVGA (320 x 240) / QQVGA (160 x 120)) to display the picture with the desired resolution.
Adjustment of the brightness of the picture
Click the buttons to adjust the brightness of the picture. The left end button
Image Size
Click one of the buttons (x1.0 / x1.5 / x2.0) to select the desired image size.
When the picture is magnified, the quality of the picture may be decreased.
AUX
Click one of the buttons (High/Low) to set the status of the AUX output connector. (Refer to p. 53 for details.)
One time pan
You can monitor the picture by panning the camera one time to the left and right.
33