
SETUP
After completing the connections, it is necessary to set up the network of the PC and the camera.
To operate the camera connected in a network such as a LAN or the Internet, it is necessary to set up the network. Use the provided "Panasonic IP Setup" software to set up the network of the camera. (Refer to the next page).
If the setup with the provided software fails, set up the PC and the camera separately. For further information, refer to pages 18 - 28.
Preparations for the Setup
Prepare the following items before starting the network setup.
STEP1
Connect the camera and the PC in either of the ways shown on the left.
Ethernet cable (Category 5 cross cable)
Ethernet switching hub
Ethernet cable (Category 5 straight cable)
AC adapter
To an outlet (120 V AC)
Notes
! Important
Use a category 5 cross cable if the camera and the PC are connected directly.
STEP2
Turn on the power of the camera after the con- nection is made.
The power is supplied to the camera by con- necting the AC adapter to an outlet.
After the power is supplied, it will take around 2 minutes before the camera can be operated.
•When the power is supplied, the power LED lights up for around 80 seconds and then blinks for around 20 sec- onds. Then the camera performs one complete panning and tilting operation.
•Confirm that the power LED and the link LED are lit after the power is supplied. If the power LED is not lit:
Confirm that the AC adapter is firmly plugged into both the camera and the outlet. If the link LED is not lit:
Confirm that the Ethernet cable is inserted firmly. Confirm also that the cable type (straight / cross) corresponds to the connection type.
15