Bosch Appliances MIC400AL operation manual NON-IR Power Supply Units, Electrical Connections

Page 14

MIC400 Series Camera Installation and Operation Manual

Electrical Connections

WARNING: Electrical Danger: Ensure all power is disconnected before opening or working upon the Power Supply Unit.

Installation must be carried out by suitably qualified persons.

A purpose built composite cable for use with the camera is available; these cables are pre-made with a Female terminated 12 way connector fitted to them for attachment to the Male connector installed into the base of the camera.

The composite cable has no termination (free wires) at the other end for wiring into the appropriate power supply. The standard colour coding used in these cables is as shown below.

Table A – MIC Composite Cable Pin table

EN 14

CHAPTER 3 Power Supply Installation & Setup

The Power Supply Units provide all the support functions for connecting the MIC400 cameras to third party equipment, they comprise of:

NON-IR Power Supply Units

MIC-240PSU, MIC-24PSU and MIC-115 PSU

The power supply provides power for a single MIC400 non-ir camera unit from either a 240v AC source (MIC-240PSU), a 24v AC (MIC-024PSU) or a 115v AC source (MIC-115PSU). The transformer fitted to these designs is a thermally protected transformer that automatically cuts out if the transformer core temperature exceeds 40 Degrees C. On cooling the transformer will become operational again.

In addition the unit provides all the terminations required to connect a MIC400 camera to third party equipment.

MIC400 Connector Pin

A

B

C

D

E

F

G

H

J

K

L

M

Signal Name

Video Output

Video Return

Tamper Sw

Tamper Sw Rtn

Washer drive Rtn

Washer drive

Full Duplex Tx A. Full Duplex Tx B.

Full Duplex Rx A. Half Duplex Tx/Rx A.

Full Duplex Rx B. Half Duplex Tx/Rx B.

Power input 1.

Power input 2.

Cable Wire Colour

Coax core

Coax screen

Black

Brown

Grey

Orange

Blue

Violet

Yellow

White

Red Green

A second independent 12v (600mA) power supply is also included to drive any internally fitted optional interface cards.

Dimensions

Power supply enclosure:-225mm (W) x 70mm (H) x 195mm (D)

The Power Supply Unit provides all the support functions for connecting the camera to third party equipment. It comprises of:

1)A weather resistant (IP55) plastic box fitted with four cable glands.

2)A power supply for the MIC400 camera.

3)A second power supply for driving various interface cards mounted internally to the power supply box. e.g. washer drive card, alarm interface card.

4)Provision for a signal interface card, to connect telemetry to third party equipment.

5)Screw termination of all cable into and out of the box.

6)Correct video termination for the camera coaxial cable.

7)Earth isolation and termination within the unit to correctly control Video earthing and thus prevent Earth loop.

Bosch Security Systems

Issue 1

Page 13 Page 15
Image 14
Page 13 Page 15
Contents MIC400 PTZ Camera Series MIC400 PTZ Camera Series Introduction Safety Precautions Important Safety Instructions Reference MIC-24PSU MIC-240PSUMIC-115PSU MIC-12PSUMIC-BP3 MIC-WKTMIC-ALM MIC-BP4Packaging Contents UnpackingInstallation Environment Key to MIC-PMB drawing Associated Equipment & Typical Installations Installation InstructionsLightning Protection Underwater InstallationEarthing of the MIC400 camera Table a MIC Composite Cable Pin table NON-IR Power Supply UnitsElectrical Connections MIC-240PSU, MIC-24PSU and MIC-115 PSUPCB Earth Link Power Supply Layout and ConnectionsTable B Power Connection to Header HD1 HD5 HD3HD4 Bi-phase cards etc Rating for Primary12 or 24 Volt vehicle supply MIC-12PSU Power Supply UnitTable G Power Input wiring connections for MIC-12PSU MIC400PA Optional Cards and Kits for Non-IR MIC400 CamerasCommissioning MIC400PA and MIC400’s with heaters fitted Heater OptionBosch Security Systems Issue MIC-IR-240PSU, MIC-IR-115PSU, MIC-IR-24PSU and MIC-IR-12PSU MIC400IR Power Supply UnitsSetting the Power Supply Link Options Figure D MIC-IR-240PSU Layout Table I Fuse Ratings for MIC-IR-240PSU Function TypeTerminal Box ID Marking SignalTable K -IR Lamp Connections HD6 Table L -Washer Pump Connection HD7MIC-IR-12PSU Figure E MIC-IR-12PSU Schematic Table M Fuse ratings for MIC-IR-12PSU Function Type RatingInstallation Instructions Table N Connecting the Greenwich Adaptor Connecting the MIC400 to the PCConnecting the Greenwich Adaptor Adaptor ConnectionsSetting Connecting the KK systems K2-ADE RS232 to RS485/422 AdaptorDIP Switch Table O K2-ADE Adaptor connectionsCommunication Mode Table Q MIC-USB485CVTR Connection Table and DiagramMIC Power Supply Converter Output Telemetry Header Standard Controls MIC-USB485CVTR and Universal Camset Software InstallationCommissioning the MIC400 through Universal Camset Boot Messages MIC SettingsCamset Settings Iris Controls Reset CamsetManual Control Pan, Tilt and Zoom Controls Focus ControlsPreset Positions AuxiliariesTour Controls Soft Stops and Non Dwell ZonesPan Reverse MIC SetupsGeneral Settings Tilt ReverseAuto Home Controls Default Settings Other controlsMulti Alarm Settings Lens Recalibration and Frame Integration Frame Integration SettingsPrivacy and Captions Privacy Controls Privacy Calibration CaptionsThermal Timers Advanced SettingsTemperature and Humidity Clear All StatisticsUpload Eeprom From File Eeprom CopierDownload Eeprom To File Remap Auxiliary Pelco OnlyMatrix Controls POT TestMenu Controls Panasonic Only Pot Test Controls Pot Test ResultsSend Direct Command CommsMIC Comms Communications TestingAlarms Cam CommsSend Preset to MIC SonySet Preset NumberGet Preset from MIC Sony SetSave Table from MIC to File Execute this PresetLoad Table from File to MIC Clear TableTable R Sonyset Commands MIC Programmer Bosch Security Systems Issue Operational AlarmsCamera Module Communication & ProtocolsEnvironmental AccessoriesPhysical ElectricalMIC400PA Twin SpeakersMIC400UL and MIC400UT MIC400S MIC400IR IR IlluminatorsDimension Drawings Asia-Pacific Contact AmericasEurope, Middle East, Africa Bosch Security Systems IncPelco Appendix a Protocol Preset codesPreset Codes Bosch Security Systems Special Setup Presets VisionBosch Security Systems Issue American Dynamics Kalatel Impossible to reach Molynx Panasonic Privacypresetend Multialarmpreset Bosch Forward Vision VCL Pantiltscaleonpreset Vicon PRIVACYSETUPBYTE2
Top Page Image Contents