A. Setting the Dive Alarm | Flashing |
|
(1) The watch enters the correction state (display is flashing) when the upper left button (C) is pressed for at least 2 seconds and then released during the dive alarm display. The flashing item on the display can be corrected.
(2)The flashing item changes in the order shown below each time the upper left button (C) is pressed once.
•The display returns to the normal display when the upper left button
(C)is pressed and then released in the dive time correction state.
Depth
(C)
No. of times
alarm sounds
(C)
Dive time
(3)Correct the flashing item by pressing either the upper right button (B) or lower right button (A).
•Pressing the upper right button (B) advances the display by one step at a time each time it is pressed, while pressing the lower right button (A) moves the display back by one step at a time each time it is pressed. (Pressing either button continuously causes the display to change rapidly.)
•Correction of the number of times the alarm sounds is skipped when the depth alarm is set to OFF.
(4)Press and release the lower left button (D) finalize the settings.
*Set each parameter to OFF when you do not want the depth alarm and dive time alarm to sound.
*The watch automatically returns to the normal dive alarm display when none of the buttons are pressed for about 3 minutes in the correction state (display flashing).
*The watch can be immediately returned to the normal dive alarm display by pressing the lower left button (D) and then releasing in the correction state (display flashing).
B. Dive Alarm Monitor
Each alarm sound repeatedly sounds for 4 seconds each in the order of the depth alarm, dive time alarm and ascent rate alarm for as long as the upper right button (B) is pressed during the dive alarm display.
* Refer to the section on "Warning Functions" for information on the ascent rate warning alarm.
59