Citizen D710/D716 instruction manual Sounds

Problem	Possible Cause	Corrective Action	Reference
Watch exhibits an	The display or operation of the	Perform the all-reset procedure.	“All-Reset”
abnormal display	watch may rarely become	If the problem is still not	“Formatting Flash
or operation	abnormal if the watch is	corrected after performing the all-	Memory”
(digital display is	mistakenly subjected to a	reset procedure, format flash
incorrect or alarm	strong impact or strong static	memory after performing the all-
sounds	electricity.	reset procedure. If the problem
continuously,		is still not resolved, consult the
etc.)		Citizen Service Center.
Unable to	The OS of the personal computer	Recheck whether the	“Accessory
install	or peripheral environment in	environment of the personal	Software”
provided	which it is used is not supported	computer being used is
software	by the software.	supported by the software.
Data cannot	The USB driver has not been	Install the USB driver.	“Data
be transferred	installed.		Communication
using USB			Functions”
	Properly connect the personal	After first disconnecting all
interface			“Communication
	computer, communication unit	devices, try reconnecting them
			Unit”
	and watch with the USB cable.	correctly.
	The watch is in the low power	The low power mode can be	“Low Power Mode
	mode.	cancelled by simultaneously pressing	(Temporary
		the lower right button (A) and lower	Function)”
		left button (D) for 2 seconds or more.
	Interface settings are incorrect	Change the interface used	Refer to the
	during data reception.	during data reception to “USB”.	manuals for each
			of the software
			contained on the
			CD-ROM.
Data cannot	The watch is not set to the data	Set the watch display to the	“Data
be transferred	transfer display of the infrared	data transfer display of the	Communication
by infrared	communication mode.	infrared communication mode.	Functions: 1.
interface			Infrared
			Communication”
	The personal computer is not	Data cannot be transferred by	“Data
	equipped with an infrared	infrared transfer. Use the USB	Communication
	communication function.	interface to transfer data.	Functions: 2.
			Communication by
			USB Interface”
	The watch and the infrared	Properly position the respective	“Data
	reception unit of the personal	infrared transmission and	Communication
	computer are not properly	reception units of the watch and	Functions: 1.
	positioned. In addition, the	personal computer, fix them in	Infrared
	corresponding infrared	position and then try	Communication”
	reception units of the watch and	transferring data again.
	personal computer have moved
	away from each other during
	the course of communication.
	The interface setting during	Change the interface used	Refer to the manuals
	infrared reception is incorrect.	during data reception to “IrDA”.	for each of the
			software contained
			on the CD-ROM.

96