Tunturi T20 owner manual Assembly

ASSEMBLY

As for the assembly of the device, we recommend two grown-up persons. Use the packing material to cover the floor on the assembly site.

Before assembling the device, insure all parts are present:

1.Frame

2.Power cord

3.Assembly kit (contents are marked with an * in the spare part list): keep the assembly tools, as you may need them e.g. for adjusting the equipment

In case of problems contact your Tunturi dealer. The directions left, right, front and back are defined as seen from the exercising position. To avoid injury, you must fold up the deck prior to lifting the treadmill out of the box.

Take the treadmill out of the box, and lay the treadmill flat on floor as shown in Figure 1. Locate the hardware bag and parts that are listed in the chart below.

A EH

B F

C

D G

Part#	Description	Q´TY
A	Screw M8x20L	6
B	Washer Ø8xØ18	2
C	Washer Ø10xØ25	4
D	Screw M4x6L	6
E	Allen Key	1
F	Screwdriver	1
G	Safety Key	1
H	Side Cap	2

O W N E R ' S M A N U A L • T 2 0

Lift up the upright, then place the screws (A) and washers (B, C) inside holes at the bottom of the upright. Use the screwdriver (F) to tighten them well.

Put the console to the correct position. Use the allen key (E) to tighten the screws (A) and washers (C) inside holes at the top of the upright.

Attach side cap (H) with the screws (D) at the bottom of the upright, and tighten them well.

G B

3