STEP 5:
•Insert two GUIDE RODS (33) through the SHROUD SUPPORT BRACKET (16) and into the TOWER BASE (10) as shown on FIGURE 5.
•(NOTE: Lubricate GUIDE RODS (33) with silicon or teflon spray available at most hardware stores.)
•Slide two 3/4 X 2” WEIGHT STACK CUSH- IONS (32) down over the GUIDE RODS (33) as shown in FIGURE 5.
•Using EXTREME CARE slide all twenty WEIGHT PLATES (34) down over the GUIDE RODS (33) on to the WEIGHT STACK CUSH- IONS (32). Make sure that the WEIGHT PLATES (34) are all facing as shown.
•Slide the HEAD PLATE ASSEMBLY (36) down over the GUIDE RODS (33) onto the weight stack as shown in FIGURE 5.
•Slide two 13/16” SHAFT COLLARS (39) over the GUIDE RODS (33) as shown in FIGURE 5.
•Apply WEIGHT STACK LABELS (74) to WEIGHT PLATES (34) and HEAD PLATE (36) as shown in FIGURE 5. Begin with number one at the HEAD PLATE (36) with larger numbers in consecutive order towards bottom of weight stack.
•Repeat STEP 5 to assemble two more weight stacks to the TOWER BASE (10).
FIGURE 5
10
39
33
36
34
74
32 
16
10