Life Fitness FIT 3 manual Adjustment

Page 40

ADJUSTMENT

FIGURE 47

STEP 47:

•Adjustments can be made in the above locations to set the correct amount of tension in the cables.

•If upon completion of assembly, the HEAD PLATE (36) does not sit on top of the first WEIGHT PLATE (34), push the HEAD PLATE (36) down, insert the WEIGHT STACK PIN (38) and perform several repetitions. This will relax the cable system and prevent the HEAD PLATE (36) from lifting up. See FIGURE 47.

•If after completing the previous step, the HEAD PLATE (36) still does not sit on top of the first WEIGHT PLATE (34) or if there is excess slack in the cable system, adjust the threaded ends of the CABLES attached to the HEAD PLATE (36) and the 3/4 X 3-1/8” TAPPED SHAFT (30) accordingly and retighten the jam nuts. See FIGURE 47.

•For maximum performance, the HEAD PLATE (36) should just barely sit on the top WEIGHT PLATE (34).

40

Page 39 Page 41
Image 40
Page 39 Page 41
Contents FIT Series FIT-3 LEG Press Main Unit Parts List LEG Press Parts List Height Lock NUT SAE Washer 22 1/2 X 3 Shoulder Bolt Flange Spacer Step 104 3/8 X 117mm Remove CAP Before Assembly 55 3/8 X 67mm Step 100 110 120 130 140 150 Tighten Lubrication Note Step X 50mm Shaft to rotate freely Step 56 3/8 X 70mm 51 3/8 X 43mm X 164mm Spring PIN X 164mm X 106mm Button Head Cable to the second set of holes Loctite X 70mm X 67mm 54 3/8 X 61mm 51 3/8 X 43mm Step Black 49 3/8 X 25mm X 90mm RH Washers 107, one 2-7/8 X 2-1/4 Cable 100 110 120 130 140 150 X 67mm 105 107 X 117mm 109 109 107 109 105 107 106 Step Step Step Adjustment Serial # Warranty Information
Top Page Image Contents