FIGURE 7 |
|
| 69 |
| 3/8 X 90mm | 58 | |
|
| ||
|
| 67 66 | 65 |
| 11 |
|
|
|
| 9 |
|
57 | 3/8 X 73mm |
|
|
14 |
|
|
|
STEP 7:
•LOOSELY assemble the LAT/LOW BOOM (11) to the LAT/LOW FRAME (14) and the TOWER UPRIGHT (9) using seven RH CAPS (69), two 3/8 X 73mm BOLTS (57), two 3/8 X 90mm BOLTS (58), seven 3/8” SAE WASHERS (66), seven 3/8” RH WASHERS (67) and three 3/8” LOW HEIGHT LOCK NUTS (65) as shown in FIGURE 7.
| 69 |
|
3/8 X 90mm | 58 |
|
| 66 |
|
| 67 | 15 |
11 |
| |
|
| |
|
| 39 TIGHTEN! |
| 65 |
|
FIGURE 8 |
|
|
STEP 8:
•SECURELY assemble the three SHROUD BRACKETS (15) to the LAT/LOW BOOM (11) using six RH CAPS (69), six 3/8 X 90mm BOLTS (58), twelve 3/8” SAE WASHERS (66), six 3/8” RH WASHERS (67) and six 3/8” LOW HEIGHT LOCK NUTS (65) as shown in FIGURE 8. (NOTE: Use RH WASHERS and RH CAPS on top only.)
•Slide the 13/16” SHAFT COLLARS (39) up against the SHROUD BRACKETS (15) and SECURELY tighten the set screws on the SHAFT COLLARS (39). See FIGURE 8.
12