Life Fitness FIT 3 manual 104 3/8 X 117mm

Page 7

65

85

67

66

104 3/8 X 117mm

69

10

FIGURE 2

STEP 2:

LOOSELY assemble the LEG PRESS FRAME (85) to the TOWER BASE (10) using four RH CAPS (69), two 3/8 X 117mm BOLTS (104), four 3/8” SAE WASHERS (66), four 3/8” RH WASHERS (67) and two 3/8” LOW HEIGHT LOCK NUTS (65) as shown in FIG- URE 2. (NOTE: The two 3/8 X 117mm BOLTS (104) for this step are in the LEG PRESS hardware bag.)

7

Image 7
Contents FIT Series FIT-3 LEG Press Main Unit Parts List LEG Press Parts List Height Lock NUT SAE Washer 22 1/2 X 3 Shoulder Bolt Flange Spacer Step 104 3/8 X 117mm Remove CAP Before Assembly 55 3/8 X 67mm Step 100 110 120 130 140 150 Tighten Lubrication Note Step X 50mm Shaft to rotate freely Step 56 3/8 X 70mm 51 3/8 X 43mm X 164mm Spring PIN X 164mm X 106mm Button Head Cable to the second set of holes Loctite X 70mm X 67mm 54 3/8 X 61mm 51 3/8 X 43mm Step Black 49 3/8 X 25mm X 90mm RH Washers 107, one 2-7/8 X 2-1/4 Cable 100 110 120 130 140 150 X 67mm 105 107 X 117mm 109 109 107 109 105 107 106 Step Step Step Adjustment Serial # Warranty Information