Life Fitness FIT 3 manual Step

Page 28

FIGURE 31

73

65

26

10

66

51 3/8 X 43mm

STEP 31:

•Route the MULTI PRESS CABLE (73) under the weight stack and through the bracket on the TOWER BASE (10) and assemble one 4-1/2” PULLEY (26) to the TOWER BASE (10) using two 3/8 X 43mm BOLTS (51), four 3/8” SAE WASHERS (66) and two 3/8” LOW HEIGHT LOCK NUTS (65) as shown in FIGURE 31.

28

Page 27 Page 29
Image 28
Page 27 Page 29
Contents FIT Series FIT-3 LEG Press Main Unit Parts List LEG Press Parts List Height Lock NUT SAE Washer 22 1/2 X 3 Shoulder Bolt Flange Spacer Step 104 3/8 X 117mm Remove CAP Before Assembly 55 3/8 X 67mm Step 100 110 120 130 140 150 Tighten Lubrication Note Step X 50mm Shaft to rotate freely Step 56 3/8 X 70mm 51 3/8 X 43mm X 164mm Spring PIN X 164mm X 106mm Button Head Cable to the second set of holes Loctite X 70mm X 67mm 54 3/8 X 61mm 51 3/8 X 43mm Step Black 49 3/8 X 25mm X 90mm RH Washers 107, one 2-7/8 X 2-1/4 Cable 100 110 120 130 140 150 X 67mm 105 107 X 117mm 109 109 107 109 105 107 106 Step Step Step Adjustment Serial # Warranty Information
Top Page Image Contents