Shaft to rotate freely | Life Fitness FIT 3 instruction

	68
	14
	30
	47	21
	69
	65	67 66
	65	53 3/8 X 50mm
		53 3/8 X 50mm
		68 BLACK
	3/8 X 67mm 55
	FIGURE 14

STEP 14:

•SECURELY assemble the LAT/LOW ADJUST PLATE (21) to the LAT/LOW FRAME (14) using two BLACK RH CAPS (68), two RH CAPS (69), two 3/8 X 67mm BOLTS (55), four 3/8” SAE WASHERS (66), four 3/8” RH WASHERS (67) and two 3/8” LOW HEIGHT LOCK NUTS (65) as shown in FIGURE 14.

•Assemble the 3/4 X 3-1/8” TAPPED SHAFT (30) to the LAT/LOW ADJUST PLATE (21) using two BLACK RH CAPS (68), one 3/8 X 50mm BOLT (53), two 3/8” SAE WASHERS (66), two 3/8” RH WASHERS (67), one 3/8 X 1/2” SPACER (47) and one 3/8” LOW HEIGHT LOCK NUT (65) as shown in FIGURE 14. (NOTE: Tighten connection enough to remove play, yet allowing TAPPED

SHAFT to rotate freely.)

FIGURE 15			69
			69
69	66	46	26
69

65	67
	67
	11
				68
				BLACK
			28	51 3/8 X 43mm
	71
			3/8 X 70mm 56
			BLACK 68	69
			BLACK 68	23

STEP 15:

•Route the LAT CABLE (71) through the LAT/LOW BOOM (11) and assemble two 4-1/2” PULLEYS (26) to the BOOM (11) us- ing two RH CAPS (69), two BLACK RH CAPS (68), two 3/8 X 70mm BOLTS (56), four 3/8” SAE WASHERS (66), four 3/8” RH WASHERS (67), two 2-7/8” X 2-1/4” CABLE CLIPS (28), four 3/8 X 1/2” FLANGE SPACERS (46) and two 3/8” LOW HEIGHT LOCK NUTS (65) as shown in FIGURE 15.

•Route the LAT CABLE (71) around one 4-1/2” PULLEY (26) and assemble the PULLEY to two DUAL PULLEY PLATES (23) using two RH CAPS (69), one 3/8 X 43mm BOLT (51), two 3/8” SAE WASHERS (66), two 3/8” RH WASHERS (67) and one 3/8” LOW HEIGHT LOCK NUT (65) as shown in FIGURE 15.