Bushnell TRS-25 Setup and Operation, Installing the Battery, Installing the Sight on the Firearm

Page 4

SETUP AND OPERATION

WARNING: Insure the weapon is unloaded and the safety selector is in the ”safe” position before attempting to install, remove or perform maintenance on the sight.

Installing the Battery

a)Remove Battery Cap by turning it counter clockwise.

b)Insert a battery (type CR2032) with positive (+) end toward Cap.

c)Install Battery Cap by turning clockwise until snug. Hand tighten only, using a coin or similar item. Using tools could damage the equipment. Note: (not necessary when the sight is new) Before installing the Battery Cap (2), inspect that the O-ring is present and not damaged. Failure to do so could result in water leakage into the battery compartment.

d)Verify that red dot is present by turning the Rotary Switch clockwise.

Installing the Sight on the Firearm

The Micro Sight is designed for installation on most types of weapons, which have a MIL-Std 1913 Picatinny Rail or Weaver Rail. If your weapon does not have or support an appropriate base(s), please consult your dealer, gunsmith or other qualified source.

Installing the Sight on a Picatinny/Weaver Rail

a)Loosen the Shaft by means of the Allen Wrench, so that the Locking Bar (12) can clamp around the Picatinny/ Weaver Rail.

b)Install the Sight to the weapon Rail by tightening the Shaft). First, ensure that the Sight is correctly positioned and that the Shaft (=recoil stop) fits into a groove on the Picatinny/Weaver Rail.

To make sure that the Shaft is firmly tightened, screw the Shaft clockwise until a light resistance can be encountered.

After that, screw another 1/4 to 1/2 turn. WARNING! Do not overtighten.

c)When using Lens Covers, ensure that they are correctly positioned and can easily be opened.

d)Finally, make sure that the Shaft with Locking Bar is firmly tightened around the weapon Rail.

e)Complete zeroing according to the "Zeroing" section below.

Lens Covers

In order to preclude the loss of the lens covers when removed from the optical path of the Sight, the lens covers should be removed downwards. The rubber string will then grab around the Sight and Base.

4

Image 4
Contents Trophy Contents Pages Base Allen Wrench Shaft Battery CapBar Setup and Operation Installing the BatteryInstalling the Sight on the Firearm Installing the Sight on a Picatinny/Weaver RailZeroing Operation Under Extreme ConditionsTrouble Shooting Possible Causes/SolutionsMaintenance Operation Under Extreme ConditionsTWO-YEAR Limited Warranty FCC Compliance Statement Français Assemblage ET Préparatifs Zérotage Utilisation EN Conditions ExtrêmesLe point rouge n’apparaît pas Méthodes DE Recherche DE PanneImpossible de zéroter Garantie Limitée de Deux ans Au CANADA, envoyez à Bushnell Outdoor Products Attn. RepairsPage Commutateur rotatif Base Llave Allen Eje Tapa de la bateríaTamaño 3 mm Para la base Cierre Montaje Y Preparativos Para EL USO Puesta a cero Operación EN Condiciones ExtremasLocalización DE Fallos En EE UU, enviar a Bushnell Outdoor Products Attn. Repairs En CANADÁ, enviar a Bushnell Outdoor Products Attn. RepairsNota de la FCC Batteriedeckel Drehschalter Schiene Inbusschlüssel Schaft Größe 3 mmBatterieeinbau Zusammenbau UND Vorbereitung ZUM GebrauchMontage des Visiers auf der Waffe Staubschutzkappen Roter Leuchtpunkt Erscheint Nicht Zentrieren Nicht MöglichGewährleistungsfrist Zwei Jahre Anmerkung bezüglich FCC Richtlinien Cappuccio della manopola di regolazione dellelevazione Base Chiave a brugola 3 mm Tubo Barra diInstallazione del dispositivo di puntamento sullarma Installazione della batteriaCoperchi di protezione delle lenti Funzionamento in Condizioni Estreme AzzeramentoRicerca Guasti Possibili cause/soluzioniGaranzia Limitata PER DUE Anni Page Tampa da Bateria Base Chave de Allen 3 mm VeioInstalling the Sight on a Picatinny/Weaver Rail Como instalar a BateriaComo instalar a Mira na Arma Coberturas das LentesZeragem Funcionamento EM Condições ExtremasResolução DE Problemas Causas/Soluções PossíveisGarantia Limitada DE Dois Anos Nota da FCC Page Bushnell outdoor products