Sears 23949 FCC Information, Set the default menu if desired, Check for downloads if desired

Page 27

If no module is connected, the display will show the words NO IFIT MODULE. If no module is con- nected, go to step 10.

6.Select an audio setting for the voice of the personal trainer if desired.

Press the decrease button to view the audio setting for the voice of the personal trainer. The currently selected audio setting for the voice of the personal trainer will appear in the display.

To change the audio setting, press the Enter button repeatedly to turn the voice of the personal trainer ON or OFF.

7.Set the default menu if desired.

Press the decrease button to view the default menu setting. The default menu is the menu that will appear when you turn on the console. Press the Enter button repeatedly to select the manual mode main menu or the iFit menu as the default menu.

8Check the status of the iFit module if desired.

Press the decrease button to view the iFit sta- tus display. The words CHECK WIFI STATUS or CHECK USB STATUS will appear in the display.

Then, press the Enter button. After a few seconds, the status of the iFit module will appear in the dis- play. To exit this display, press and hold down the Display button for a few seconds.

9.Check for downloads if desired.

Press the decrease button to view the downloads display. The words SEND/RECEIVE DATA will appear in the display.

Then, press the Enter button. The console will then check for iFit workouts and firmware downloads.

10.Exit the information mode.

Press the Display button to exit the information mode.

FCC INFORMATION

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, try to correct the interference by one or more of the following measures:

•• Reorient or relocate the receiving antenna.

•• Increase the separation between the equipment and the receiver.

•• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. •• Consult the dealer or an experienced radio/TV technician for help.

FCC CAUTION: To assure continued compliance, use only shielded interface cables when connecting to computer or peripheral devices. Changes or modifications not expressly approved by the party respon- sible for compliance could void the user’’s authority to operate this equipment.

27

Page 26 Page 28
Image 27
Page 26 Page 28
Contents QUESTIONS? Model No Serial NoCall TOLL-FREE Table of Contents Important Precautions Before YOU Begin Part Identification Chart Assembly Son hold the Frame to prevent it from tippingWhile you complete this step Do not fully tighten the Screws yet Avoid pinching Wires and avoid Damaging the tabsRepeat these actions for the Left Upper Body Leg Tip To prevent the wires from falling intoUpright 4, secure the wires with the wire tie Center it. Tip It may be helpful to use a Rubber malletRepeat this step for the Left Upper Body Arm 101 Wires Tip Avoid pinching the wires. Press Page Repeat this step on the other side of the elliptical Page Chest Heart Rate Monitor HOW to PUT on the Heart Rate MonitorCare and Maintenance TroubleshootingHOW to Plug in the Power Cord HOW to USE the EllipticalHOW to Adjust the Positions of the Pedals HOW to Move the EllipticalHOW to Exercise on the Elliptical HOW to Level the EllipticalVariety, you can turn the pedals in the opposite direction Console Diagram Features of the Console HOW to Turn on the Power HOW to USE the Manual ModeSelect the manual mode Follow your progress with the display When you are finished exercising, unplug the power cord Measure your heart rate if desiredTurn on the fan if desired HOW to USE AN Onboard Workout Select an onboard workoutBegin pedaling to start the workout Set a calories, distance, or time goal HOW to USE a SET-A-GOAL WorkoutStart the workout. See on HOW to USE AN Ifit WorkoutMake sure that the iFit module is inserted in the console Select a user Select an iFit workoutHOW to USE the Sound System HOW to Change Console SettingsCheck the status of the iFit module if desired Set the default menu if desiredExit the information mode FCC InformationMaintenance and Troubleshooting Console TroubleshootingHOW to Calibrate the Ramp Exercise Frequency Exercise GuidelinesExercise Intensity Workout GuidelinesSuggested Stretches Description Qty Part ListQty Description Drawing ExplodedDrawing Exploded Drawing Ordering Replacement Parts Limited WarrantyIcon Health & Fitness, Inc., 1500 S W., Logan, UT
Top Page Image Contents