Sears 23949 Do not fully tighten the Screws yet, Avoid pinching Wires and avoid Damaging the tabs

Page 7

3.Press the Cover Mounts (106) on the underside of the Rear Stabilizer Cover (15) into the Rear Stabilizer (2).

4.Tip: Avoid pinching the wires. Avoid damag- ing the indicated plastic tabs. Set the Upright

(4) on the Frame (1).

Attach the Upright (4) with four M10 x 25mm Screws (99) and four M10 Split Washers (105).

Do not fully tighten the Screws yet.

3

15

2

106

4

Avoid pinching the

wires and avoid

damaging the tabs

4

99

105

99

105

1

Tabs

7

Image 7

Contents Model No Serial No QUESTIONS?Call TOLL-FREE Table of Contents Important Precautions Before YOU Begin Part Identification Chart Son hold the Frame to prevent it from tipping AssemblyWhile you complete this step Do not fully tighten the Screws yet Avoid pinching Wires and avoid Damaging the tabsRepeat these actions for the Left Upper Body Leg Tip To prevent the wires from falling intoUpright 4, secure the wires with the wire tie Center it. Tip It may be helpful to use a Rubber malletRepeat this step for the Left Upper Body Arm 101 Wires Tip Avoid pinching the wires. Press Page Repeat this step on the other side of the elliptical Page Chest Heart Rate Monitor HOW to PUT on the Heart Rate MonitorCare and Maintenance TroubleshootingHOW to Plug in the Power Cord HOW to USE the EllipticalHOW to Adjust the Positions of the Pedals HOW to Move the EllipticalHOW to Level the Elliptical HOW to Exercise on the EllipticalVariety, you can turn the pedals in the opposite direction Console Diagram Features of the Console HOW to USE the Manual Mode HOW to Turn on the PowerSelect the manual mode Follow your progress with the display Measure your heart rate if desired When you are finished exercising, unplug the power cordTurn on the fan if desired Select an onboard workout HOW to USE AN Onboard WorkoutBegin pedaling to start the workout Set a calories, distance, or time goal HOW to USE a SET-A-GOAL WorkoutStart the workout. See on HOW to USE AN Ifit WorkoutMake sure that the iFit module is inserted in the console Select a user Select an iFit workoutHOW to USE the Sound System HOW to Change Console SettingsCheck the status of the iFit module if desired Set the default menu if desiredExit the information mode FCC InformationConsole Troubleshooting Maintenance and TroubleshootingHOW to Calibrate the Ramp Exercise Frequency Exercise GuidelinesExercise Intensity Workout GuidelinesSuggested Stretches Description Qty Part ListQty Description Drawing ExplodedDrawing Exploded Drawing Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT