Sears 23949 user manual Part Identification Chart

Page 5

PART IDENTIFICATION CHART

Use the drawings below to identify the small parts needed for assembly. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the key number is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if it has been preassembled. Extra parts may be included.

	M5 Washer	M8 Washer	M10 Split	16mm Wave
	(94)–2	M8 Washer	M10 Split	16mm Wave
		(97)–8	Washer (105)–8	Washer (54)–2
	M4 x 16mm	M8 x 13mm	M8 x 38mm	M8 Locknut
	Screw (101)–16	M8 x 13mm	M8 x 38mm	M8 Locknut
	Screw (101)–16	Screw (82)–8	Bolt (96)–4	(102)–4
		Screw (82)–8	Bolt (96)–4	(102)–4
	M10 x 25mm		M10 x 122mm
	Screw (99)–4		Screw (104)–4

5

Image 5

Contents Call TOLL-FREE QUESTIONS?Model No Serial No Table of Contents Important Precautions Before YOU Begin Part Identification Chart While you complete this step AssemblySon hold the Frame to prevent it from tipping Do not fully tighten the Screws yet Avoid pinching Wires and avoid Damaging the tabsUpright 4, secure the wires with the wire tie Tip To prevent the wires from falling intoCenter it. Tip It may be helpful to use a Rubber mallet Repeat these actions for the Left Upper Body LegRepeat this step for the Left Upper Body Arm 101 Wires Tip Avoid pinching the wires. Press Page Repeat this step on the other side of the elliptical Page Care and Maintenance HOW to PUT on the Heart Rate MonitorTroubleshooting Chest Heart Rate MonitorHOW to Plug in the Power Cord HOW to USE the EllipticalHOW to Adjust the Positions of the Pedals HOW to Move the EllipticalVariety, you can turn the pedals in the opposite direction HOW to Exercise on the EllipticalHOW to Level the Elliptical Console Diagram Features of the Console Select the manual mode HOW to Turn on the PowerHOW to USE the Manual Mode Follow your progress with the display Turn on the fan if desired When you are finished exercising, unplug the power cordMeasure your heart rate if desired Begin pedaling to start the workout HOW to USE AN Onboard WorkoutSelect an onboard workout Set a calories, distance, or time goal HOW to USE a SET-A-GOAL WorkoutMake sure that the iFit module is inserted in the console HOW to USE AN Ifit WorkoutSelect a user Select an iFit workout Start the workout. See onHOW to USE the Sound System HOW to Change Console SettingsExit the information mode Set the default menu if desiredFCC Information Check the status of the iFit module if desiredHOW to Calibrate the Ramp Maintenance and TroubleshootingConsole Troubleshooting Exercise Intensity Exercise GuidelinesWorkout Guidelines Exercise FrequencySuggested Stretches Description Qty Part ListQty Description Drawing ExplodedDrawing Exploded Drawing Icon Health & Fitness, Inc., 1500 S W., Logan, UT Ordering Replacement PartsLimited Warranty