C O M M E R C I A L P R O D U C T S D I V I S I O N
Diagram 14 | Replace the | 1 | 2 |
| hood and | ||
|
| ||
| secure it. |
|
|
| Hood |
|
|
| Buttonhead |
|
|
| screws (A) with |
|
|
| washers (B) |
|
|
| secure the hood |
|
|
| to the siderail. |
|
|
Buttonhead screws (A) with washers (B) secure the front of the hood.
12.Replace the hood. Diagram 14. Reposition the hood on the treadmill. Re- move four buttonhead screws (A) with washers (B) from the hardware kit. Two buttonhead screws and washers are placed through the front panel and the remaining two screws and washers are used to secure the hood to the siderail. Tighten the screws using the appropriate hex keys.
Diagram 15 | Secure the | 2 |
| fasteners and | |
| replace the |
|
| hood. |
|
| Alternately |
|
| tighten four side |
|
| upright screws. |
|
| Alternately |
|
| tighten the four | 3 |
| front panel | |
| screws. | 1 |
| Alternately tighten | |
|
| |
| the four screws |
|
| that secure the |
|
| display console. |
|
13.Tighten all mounting screws with the hex keys provided. Diagram 15. Start at the front of the treadmill with the four screws that attach the upright supports to the front panel. Tightening these screws first helps pull the rest of the treadmill’s parts into alignment. Then, proceed with tightening the four sockethead screws (D) that secure the upright supports, the four console assembly screws (A), the handrail assembly screws (A) and (C), and the hood screws (shown in Diagram 14).
page 18