C O M M E R C I A L P R O D U C T S D I V I S I O N
Diagram 18 | Attach the power | 1 |
| cord clip. | |
| Cord clip |
|
| Front panel |
|
| Power cord |
|
| Incline lift | 2 |
|
|
CAUTION: To make sure the power cord is not pinched or damaged by the incline lift, attach the power cord to the base frame using the clips provided.
15.Attach the power cord clip. Diagram 18, #1. Remove a cord clip from the Hardware kit.Wrap it around the power cord near its receptacle and clamp it shut.
16.Insert the clip into the base frame. Diagram 18, #2. Insert the serrated portion of the cord clip into the hole located under the front panel on the base frame.
Diagram 19 | Install the |
| remaining |
| cord clips. |
| Side rail |
| Power cord |
17.Install the remaining cord clips. Diagram 19. Wrap at least two more cord clips around the power cord and insert the clips into the holes found in the frame beneath the side rail. The holes are spaced a foot apart (approximately 31 cm) along the length of the side rail.
18.Plug the power cord into a dedicated, grounded circuit. Place the clips as needed along the length of the power cord while you route it to the power outlet.
Important: Check the length of the power cord to make sure that it cannot get pinched or damaged by the incline lift movement.
CAUTION:The treadmill requires a dedicated, grounded circuit. A 20 amp dedicated circuit is recommended. Make sure that no other product or machine uses the same circuit as the treadmill. Refer to Grounding Instructions.
page 20