C O M M E R C I A L P R O D U C T S D I V I S I O N
TURNING THE UNIT ON AND OFF
Use the ON/OFF (I/O) power switch, located on the front panel, to turn the unit ON and OFF.
To complete the installation of the treadmill, continue with Checking the Alignment of the Running Belt.
CHECKING THE ALIGNMENT OF THE RUNNING BELT
Proper belt alignment allows the belt to remain centered and ensures smooth operation. Realigning the belt takes a few simple adjustments and is explained in the Maintenance section.
Follow these steps to check the alignment:
1.The treadmill has adjustable rear feet. Make sure that the running surface is level. Refer to step 14, Diagram 16.
2.Turn the unit ON.
3.Stand beside the treadmill and press QUICKSTART.
4.If you are prompted for a password, press INCLINE ▼, SPEED ▼, SPEED ▲. The running belt starts automatically after a
5.Press the SPEED ▲ key until the display shows a speed of 3 miles per hour (5 kph).
6.Walk around to the rear of the unit and observe the belt for a few minutes. The belt should run centered along the running bed. If the belt drifts off center, you will need to make adjustments.
Important: If the belt needs alignment, make the adjustments immediately after turning the treadmill OFF. Failure to do so might cause the belt to tear or fray, which is not covered by the Precor Limited Warranty.
7.To stop the running belt, press the red STOP button.
8.Turn the treadmill OFF.
If the belt is functioning correctly, the treadmill is ready to use. Please continue reading Club Information to learn how to customize the treadmill for your club.
page 21