C O M M E R C I A L P R O D U C T S D I V I S I O N
4.Stand beside the treadmill and press QUICKSTART.
5.If you are prompted for a password, press INCLINE ▼, SPEED ▼, SPEED ▲. The running belt starts automatically after the
6.Press the SPEED ▲ key until the display shows a speed of 3 mph (5 kph).
7.Walk around to the rear of the unit and observe the running belt for a few minutes. The belt should run centered along the running bed. If the belt drifts off center, you will need to make adjustments.
CAUTION: If you hear any chafing or the running belt appears to be getting damaged, stop the running belt immediately by pressing the red STOP button. Contact Precor Customer Support.
8.If the belt needs additional alignment, repeat steps 1 through 7 until the belt is properly aligned.
9.After aligning the belt, press the STOP button and RESET. Turn OFF the tread- mill. Tighten any loose fasteners or other components on the equipment. If you hear unusual noises or you feel that the treadmill is in need of repair or service, contact Precor Customer Support. Refer to Obtaining Service.
STORING THE CHEST STRAP
Store the chest strap transmitter in a place where dust and dirt cannot accumu- late on it such as, a closet or drawer. Be sure to keep the chest strap protected from extremes in temperature. Do not store it in an area that may be exposed to temperatures below 32° Fahrenheit.
SERVICING THE TREADMILL
Do not attempt to service the treadmill yourself except for the maintenance tasks described in this manual. The unit does not contain any
LONG TERM STORAGE
When the treadmill is not in use for any length of time, turn it OFF. Ensure that the power cord is unplugged from the wall outlet and is positioned so that it will not become damaged or interfere with other equipment or people.
page 51