Selecting the Analog or Digital Input Mode
When you have connected digital source components using both the analog connection and the digital connection methods (see page 6), you need to select the input mode correctly.
1Press one of the source selecting buttons (DVD, TV, or CD)* for which you want to change the input mode.
If the following symptoms occur while playing Dolby Digital or DTS Digital Surround software with “DGTL AUTO” selected, follow the procedure below.
•Sound does not come out at the beginning of playback.
•Noise comes out while searching or skipping chapters or tracks.
1Press one of the source selecting buttons (DVD, TV, or CD) for which you want to change the input mode.
DVD | TV | VCR | CD |
Basic Settings
DVD | TV | VCR | CD |
Note:
*Among the sources listed above, you can select the digital input only for the sources which you have selected the digital input terminals for. (See “Setting the Digital Input Terminals” on page 10.)
2Press INPUT ANALOG/DIGITAL (or INPUT A/ D on the remote control) to select the analog or digital input mode.
•Each time you press the button, the input mode alternates between the analog input (ANALOG) and the digital input (DGTL AUTO).
INPUT
ANALOG/DIGITAL
INPUT ATT
L C R | MUTIN | ||||
|
|
|
|
|
|
SUBWFR LFE | MHZ | |
DOLBY D | DGTL AUTO | KHZ |
LS | RS | VOL |
2Press INPUT ANALOG/DIGITAL (or INPUT A/D) to select the
digital input mode (DGTL AUTO).
INPUT
ANALOG/DIGITAL
INPUT ATT
3 Press CONTROL 3(or 2) to select “DGTL D.D.” or “DGTL DTS” while “DGTL AUTO” still remains on the display.
• Each time you press the button, the digital input mode changes as follows:
CONTROL
When “DGTL D.D.” or “DGTL DTS” is selected, “AUTO” goes off.
L C | R | MU |
SUBWFR LFE | MH | |
DOLBY D | DGTL AUTO | KH |
LS | RS | VO |
DGTL AUTO : Select this for the digital input mode. The receiver automatically detects the incoming signal format. (The DGTL AUTO indicator lights up on the display, then the digital signal indicator for the detected signals lights up.)
ANALOG : Select this for the analog input mode. (Initial setting when shipped from the factory)
•To play back software encoded with Dolby Digital, select “DGTL D.D.”
•To play back software encoded with DTS Digital Surround, select “DGTL DTS.”
Note:
When you turn off the power or select another source, “DGTL DTS” and “DGTL D.D.” are canceled and the digital input mode is automatically reset to “DGTL AUTO.”
The following are the analog/digital signal indicators on the display to indicate what type of the signal comes into the receiver.
ANALOG : Lights when the analog input is selected.
LPCM : Lights when Linear PCM signals come in.
DOLBY D : • Lights when Dolby Digital signals come in.
•Flashes when “DGTL D.D.” is selected for software not encoded with Dolby Digital.
DTS : • Lights when DTS Digital Surround signals come in.
•Flashes when “DGTL DTS” is selected for software not encoded with DTS Digital Surround.
Note:
When “DGTL AUTO” cannot recognize the incoming signals, no digital signal indicators light up on the display.
11