JVC RX-E100SL manual 0301NHMMDWJEIN

Page 42

VICTOR COMPANY OF JAPAN, LIMITED

EN	V	0301NHMMDWJEIN
	J C	0301NHMMDWJEIN

Image 42

Contents RX-E100SL For Canada/pour Le Canada Table of Contents Checking the Supplied Accessories Before InstallationPutting Batteries in the Remote Control Getting StartedStarted Connecting the FM and AM AntennasGetting AM antenna connectionConnecting the front, center, and rear speakers Connecting the SpeakersSpeaker Layout Diagram Connecting the subwooferLeft front speaker Connecting cords are not supplied with this unit. Use Connecting Audio/Video ComponentsConnecting the Power Cord Digital connectionsDVD To increase the volume, press and hold Turn On the PowerTo turn off the power into standby To decrease the volume, press and holdTurning Off the Power With the TimerBasic Operations Press Setting Basic SettingsSetting the Digital Input TerminalsBasic Settings Selecting the Analog or Digital Input ModeWhen Dgtl D.D. or Dgtl DTS is selected, Auto goes off DSP Modes Setting the Subwoofer InformationSetting the Speakers for Press Control 3or 2 to select YESPress Control 3 or 2 to select the appropriate speaker size Delay Time CTR DL, Rear DLEx. When registering the rear speaker size DisplayEx. When adjusting the center delay Press Control 3or 2 to select the delay timeRepeat steps 2 and 3 to adjust the other delay time Crossover Frequency CrossPress Control 3or 2 to select the LFE attenuator level Dynamic Range Compression D.R.CLow Frequency Effect Attenuator LFE To activate Auto Surround, follow the procedure below Setting Auto SurroundTo cancel Auto Surround Each time you press the button, Auto Surround turns on orAttenuating the Input Signal Sound AdjustmentsBasic Settings/Sound Adjustments Adjusting the Front SpeakerWhen using the remote control Reinforcing the BassPress Control 3 or 2 to turn on or OFF Bass Boost Sound Adjustments Adjusting the ToneAdjusting the Subwoofer Output Level Tuner Operations Tuning in Stations ManuallyUsing Preset Tuning Press FM or AM to select the bandTo restore the stereo effect Selecting the FM Reception ModeTo tune in a preset station Tuner OperationsCreating Realistic Sound Fields DAP Digital Acoustic Processor Modes Available DSP modes according to the input signal formatCreating Realistic Sound Fields Creating sound fieldWhen Auto SR Auto Surround is turned on Surround modeDSP mode About Relations between Speaker Layout and DSP ModesUsing Surround Modes Remote Control Press Test to check the speaker output balance Adjust the following speaker output levels from -10 to +10Using Theater Surround Remote Control Press Test again to stop the test toneTo cancel Theater Surround Press Effect to select the DSP effect level 1 to You wantUsing DAP Modes Remote Control Adjust the rear speaker output levels from -10 to +10To cancel DAP Mode Digital, or DTS Digital Surround Using Surround Modes Front PanelPress Surround ON/OFF to activate an SeeUsing Theater Surround Front Panel Press Control 3or 2 to adjust the speaker output levelEx. When adjusting the center speaker output level Using DAP Modes Front Panel Press Control 3or 2 to make an adjustmentRepeat steps 4 and 5 to make other adjustments Ex. When adjusting the left rear speaker output levelMastering Remote Operations Mastering Remote Operations Operating other JVC products Audio/video operation buttonsRemote Control Parts IdentificationFront Panel Troubleshooting Parts Identification/TroubleshootingFM tuner IHF SpecificationsAmplifier AM tunerMemorandum Source Name781 954 650 Valley Road Wayne, NJ1099 Limited Warranty AUDIO-2 0301NHMMDWJEIN