4Press MEMORY again while the selected channel
number is flashing on the display.
The selected channel number stops flashing.
The station is assigned to the selected channel number.
MEMORY
TUNED ST AUTO MUTING
MHZ |
VOL |
5Repeat steps 1 to 4 until you store all the stations you want.
To erase a stored preset station
Storing a new station on a used channel number erases the previously stored one.
To tune in a preset station
1Press FM or AM to select the band.
The last received station of the selected band is tuned in, and the CONTROL buttons now work for tuner operations.
FM | AM | TUNED ST AUTO MUTING |
MHZ |
VOL |
Ex.: When selecting the FM band
2Press CONTROL °(or 5) repeatedly until “< PRESET >” appears on the display.
| Remote |
Selecting the FM Reception Mode | NOT |
When an FM stereo broadcast is hard to receive or noisy, you can change the FM reception mode while receiving an FM broadcast.
• You can store the FM reception mode for each preset station.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
1While listening to an FM station, press CONTROL ° (or 5) repeatedly until “<FM MODE>” appears on the display.
CONTROL
TUNED ST AUTO MUTING
MHZ |
VOL |
2Press CONTROL 3(or 2) to select “MONO.”
•Each time you press the button, the FM reception mode alternates between “AUTO MUTING” and “MONO.”
CONTROL
ANALOG L | R | TUNED |
MHZ
VOL 
Tuner Operations
CONTROL
TUNED ST AUTO MUTING
VOL 
* “AUTO MUTING” is the initial setting.
Then
TUNED | ST | AUTO | MUTING |
|
|
| MHZ |
VOL |
Preset channel number appears.
3Press CONTROL 3or 2to select a preset channel number you want.
CONTROL
TUNED ST AUTO MUTING
MHZ |
VOL |
•Pressing (or holding) CONTROL 3increases the preset channel numbers.
•Pressing (or holding) CONTROL 2decreases the preset channel numbers.
When using the remote control
1Press FM or AM.
The last received station of the selected band is tuned in, and the 10 keys now work for tuner operations.
2Press the 10 keys to select a preset channel number.
•For channel number 5, press 5.
•For channel number 15, press +10 then 5.
•For channel number 30, press +10, +10, then 10.
MONO : Select this to improve the reception (but stereo effect will be lost).
In this mode, you will hear noise while tuning into the stations. The AUTO MUTING indicator goes off from the display. (The ST indicator also goes off.)
AUTO MUTING : Normally select this. When a program is broadcasted in stereo, you will hear stereo sound; when in monaural, you will hear monaural sounds. This mode is also useful to suppress static noise between stations. The AUTO MUTING indicator lights up on the display.
To restore the stereo effect
Repeat step 1, then select “AUTO MUTING” in step 2.
21