JVC RX-E100SL manual Connecting the Speakers, Speaker Layout Diagram, Connecting the subwoofer

Getting Started

Connecting the Speakers

Speaker Layout Diagram

After connecting the front, center, rear speakers and/or a subwoofer, set the speaker setting information properly to obtain the best possible DSP effect. For details, see page 12.

CAUTION:

Use speakers with the SPEAKER IMPEDANCE indicated by the

speaker terminals.

» Æ

Connecting the front, center, and rear speakers

1 2 3

Right rear speaker

For each speaker, connect the (+) and (–) terminals on the rear panel to the (+) and (–) terminals marked on the speakers respectively.

1Cut, twist and remove the insulation at the end of each speaker cord (not supplied).

2Open the terminal, then insert the speaker cord.

3Close the terminal.

Connecting the subwoofer

By connecting a subwoofer, you can enhance the bass or reproduce the original LFE signals recorded in the digital software.

	»
	Æ
Powered subwoofer
(example)	SUBWOOFER
	OUT
INPUT
HIGH IMPEDANCE

Connect the input jack of a powered subwoofer to the SUBWOOFER OUT jack on the rear panel, using a cable with RCA pin plugs (not supplied).

•Refer also to the manual supplied for your subwoofer.

Since bass sound is non-directional, you can place a subwoofer wherever you like. Normally place it in front of you.

4