JVC RX-9010VBK manual Changing the Source Name, Showing the Text Information on Display

Changing the Source Name

When you have connected an MD recorder to the TAPE/MD jacks or the DBS tuner to the TV SOUND/DBS jacks on the rear panel, change the source name which will be shown on the display when you select the MD recorder or DBS tuner as the source.

•When you select DBS as a source for the sub-room, you cannot change the source name.

On the front panel ONLY:

When changing the source name from “TAPE” to “MD”:

•Press and hold SOURCE NAME (TAPE/MD) until “ASSGN. MD” appears on the display.

TAPE / MD

SOURCE NAME

When changing the source name from “TV ” to “DBS”:

• Press and hold SOURCE NAME (TV SOUND/ DBS) until “ASSGN. DBS” appears on the display.

TV SOUND/DBS

SOURCE NAME

To change the source name to “TAPE” or “TV,” repeat the same procedure above — press and hold SOURCE NAME (TAPE/MD) to select “TAPE,” or press and hold SOURCE NAME (TV SOUND/DBS) to select “TV.”

Showing the Text Information on the

Display

When you have connected an MD recorder or CD player equipped with TEXT COMPU LINK remote control system (see page 57), you can show the text information, such as disc title or track title, on the display of this receiver. To show it on the display, follow the procedure below.

Before you start, remember....

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

On the front panel ONLY:

1.Press SETTING repeatedly until “FL DISP” (Display) appears on the display.

SETTING

The display changes to show the current setting.

2.Press CONTROL UP 5/DOWN °to select either the source name or the text information to be shown on the display.

CONTROL

DOWN UP

•Each time you press the button, the display changes to show the following:

Note:

Without changing the source name, you can still use the connected components. However, there may be some inconvenience.

•“TAPE” or “TV SOUND” will appear on the display when you select the MD recorder or DBS tuner.

•You cannot use the digital input (see page 30) for the MD recorder.

•You cannot use the COMPU LINK remote control system (see page 55) to operate the MD recorder.

NORM TEXT (Normal)

NORM: Source name and Surround/DSP appear during play.

TEXT: Text information appears during play.

Note:

Though you have selected “TEXT,” the source name and Surround/

DSP mode appear if a playing disc has no text information.

33