JVC RX-9010VBK manual Same time, Press the play 3 button on the CD player, Synchronized Recording

Automatic Power On/Off (Standby): only possible with the COMPU LINK-3 and COMPU LINK--4 connection

Automatic Power On:

•When you turn on the receiver by pressing POWER on the front panel or AUDIO POWER ON on the remote control (with MAIN ROOM/SUB ROOM selector set to “MAIN ROOM”):

OR

When you turn on the main room sound by pressing MAIN ROOM ON/OFF while the receiver is turned on:

\The MAIN ROOM indicator and the source name for the main room light up on the display, and one of the connected components will turn on automatically, depending on which component has been previously selected as the main room source.

•When you turn on the receiver by pressing

AUDIO POWER ON on the remote control (with MAIN ROOM/SUB ROOM selector set to “SUB ROOM”):

OR

When you turn on the sub-room sound by pressing SUB ROOM ON/OFF while the receiver is turned on:

\The SUB ROOM indicator and the source name for the sub- room light up on the display, and one of the connected components will turn on automatically, depending on which component has been previously selected as the sub-room source.

Automatic Power Off (Standby):

•When you turn off the receiver by pressing POWER, the connected components will turn off (standby).

•When you turn off the main room sound by pressing MAIN ROOM ON/OFF, the selected main room source component turns off (unless the same component is selected as the sub-room source).

–If the SUB ROOM indicator and the source name for the sub- room are lit on the display, the main room source will stop playing, but will not turn off.

•When you turn off the sub-room source by pressing

SUB ROOM ON/OFF, the selected sub-room source component turns off (unless the same component is selected as the main room source).

–If the MAIN ROOM indicator and the source name for the main room are lit on the display, the main room source will stop playing, but will not turn off.

Synchronized Recording

This operation is only possible while the receiver is ready for the main room operations.

Synchronized recording means the cassette deck (or MD recorder) starts recording as soon as a CD begins playing.

•When using a CD player for synchronized recording, refer to the manual supplied with it.

To use synchronized recording, follow these steps:

1.Put a tape in the cassette deck (or an MD in the MD recorder), and a disc in the CD player.

2.Press the record (¦) button and the pause (8) button on the cassette deck (or MD recorder) at

the same time.

This puts the cassette deck (or MD recorder) into recording pause.

If you do not press the record (¦) button and pause (8) button at the same time, the synchronized recording feature will not operate.

3. Press the play (3) button on the CD player.

The main room source changes on the receiver, and as soon as play starts, the cassette deck (or MD recorder) starts recording. When the play ends, the cassette deck (or MD recorder) enters recording pause, and stops about 4 seconds later.

Notes:

•During synchronized recording;

–the selected main room source cannot be changed. (You can change the sub-room source.)

–If the same source is selected both for the main room and the sub-room, operating the sub-room source will affect the recording.

•The COMPU LINK remote control system may not operate properly during synchronized recording;

–If the power of any component is shut off.

–If the main room sound is turned off by pressing

MAIN ROOM ON/OFF.

In this case, you must start again from the beginning.

56