JVC RX-9010VBK manual Compu Link Remote Control System, Turntable, Automatic Source Selection

COMPU LINK Remote Control System

The COMPU LINK remote control system allows you to operate JVC audio components through this receiver.

To use this remote control system, you need to connect JVC audio components through the COMPU LINK (SYNCHRO) jacks (see below) in addition to the connections using cables with RCA pin plugs (see pages 7 and 8).

•Make sure that the AC power cords of these components are unplugged before connection. Plug the AC power cords only after all connections are complete.

CD player

CD recorder

Cassette deck

or

MD recorder

RX-9010VBK

COMPU LINK – 4

(SYNCHRO)

Turntable

IMPORTANT:

Check to see if the proper indicator(s) and information appear on the display on the front panel before/while using the buttons and controls.

Notes:

•There are four versions of COMPU LINK remote control system. This receiver is equipped with the fourth version — COMPU LINK- 4. This version is created by adding systematic operations with the CD recorder to the previous version — COMPU LINK-3.

•If your audio component has two COMPU LINK jacks, you can use either one. If it has only one COMPU LINK jack, connect it so that it is the last item in the series of components. (For example, the turntable or CD player in the diagram above.)

•To operate the cassette deck or MD recorder using the COMPU LINK remote control system, set the source name correctly. (See page 33.)

•Refer also to the manuals supplied with your audio components.

This remote control system allows you to use four functions listed below.

Remote Control through the Remote Sensor on the Receiver

You can control the connected audio components through the receiver using this remote control. For details, see pages 65 – 67.

Automatic Source Selection

•When you press the play (3) button on a connected component or on its own remote control, the receiver automatically turns on and changes the main room source to the component.

ANALOG	L	R
			MAIN ROOM
	SPEAKERS
1			VOLUME

–If the receiver is already turned on, and the SUB ROOM indicator and the source name for the sub-room are lit on the display, the receiver changes the sub-room source to the component.

SPEAKERS	SUB ROOM
SUB ROOM	VOLUME

When using the buttons and controls on the front panel:

•For the main room operations

–The MAIN ROOM indicator is lit.

–The source name for the sub-room is not lit on the display.

•For the sub-room operations

–The SUB ROOM indicator is lit.

–The source name for the sub-room is lit on the display.

When using the remote control:

• For the main room operations

– Set MAIN ROOM/SUB ROOM selector to

“MAIN ROOM.”

MAIN ROOM SUB ROOM

•For the sub-room operations

–Set MAIN ROOM/SUB ROOM selector to “SUB ROOM.”

• When you press PLAY on the remote control
supplied for this receiver, the receiver	PLAY

automatically turns on and changes the main room source or sub-room source (depending on

MAIN ROOM/SUB ROOM selector setting on the remote control) to the target component.

•When you select a new source on the receiver or on the remote control supplied for this receiver either for the main room or sub- room, the newly selected component begins playing immediately, and the previously selected source continues playing without sound for a few seconds.

55