JVC RX-9010VBK manual Basic Setting and Adjustment Auto Memory, To store the volume level

Basic Setting and Adjustment — Auto

Memory

Without any setting required, this receiver stores different sound settings for each different playing source automatically whenever you do the following:

•Turning on the power (see page 17)

•Changing the source to play (see page 18)

•Changing the source name (see page 33)

So, you do not have to change the sound settings next time you select the same source. The stored settings for the selected source are automatically recalled.

The following settings are automatically stored for each source:

•Analog/digital input mode (see page 31)

•Bass boost (see page 21)

•Digital equalization adjustment (see page 20)

•DVD MULTI playback mode setting (see page 49)

•Front speaker output balance (see page 27)

•Input attenuator mode (see page 21)

•Line direct (see page 22)

•Midnight mode (see page 21)

•Subwoofer setting and its output level (see pages 21 and 28)

•Surround mode on/off (see page 39)

•Surround/DSP mode setting (see pages 40 – 48)

You can also assign and store the volume level for each source. See “To store the volume level” to the right.

Notes:

•This function cannot be used for the sub-room sources.

•If the source is FM or AM, you can assign different settings for each band.

•You cannot assign and store different settings for digital input mode and analog input mode (when selecting a digital source).

•The Surround modes and DSP modes cannot be used with DVD MULTI playback mode at the same time.

To store the volume level

(ONE TOUCH OPERATION)

Before you start, remember....

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

On the front panel ONLY:

1.Press SETTING repeatedly until “ONE TOUCH” appears on the display.

SETTING

The display changes to show the current setting.

2.Press CONTROL UP 5/DOWN °to turn on the

One Touch Operation.

CONTROL

DOWN UP

The ONE TOUCH OPERATION indicator lights up on the display.

•Each time you press the button, the one touch operation function turns on (“ON”) and off (“OFF”).

To recall the volume level

With the ONE TOUCH OPERATION indicator lit, the volume level for the currently selected source is recalled when the source is selected.

To cancel the One Touch Operation

Select “OFF” in step 2 above so that the ONE TOUCH OPERATION indicator goes off. (Even though the One Touch Operation is canceled, the recalled volume remains active.)

34