Siemens WFXD5202UC manual Supply Line Connection, Storing Transport Bolts

q	Loosen	all four		bolts	before	Storing	the	transport	bolts
	removing	any	of	the	bolts all the	Always	keep	the transport bolts for fuu
	way from the unit.					ture transportation of the appliance
q	Remove	the	bottom		two bolts prior(such as when moving				out).
	to removing		the	top	two bolts.	q Store the		transport	bolts with the
q	Loosen	the bolts using the closed				washer and bushing			attached.
	end of the 1/2" wrench provided.
	Loosen them until they can be reu
	moved freely.

qThe recessed bottom bolts may be more easily removed using a 1/2" (13 mm) socket wrench.

ATTENTION

To prevent water damage, the hot and cold water valves should be accessible when the washing machine is in place and should always be turned off when the washing machine is not in use.

ATTENTION

If installing the washing machine in a new building or a building in which the plumbing system was recently installed or upgraded, flush the lines before installing the washing machine to remove any sand, dirt or residue.

Supply Line Connection

qCompletely remove all 4 transport bolt assemblies (bolt, spring, washer and bushings) by reaching through the open washing machine door and

pulling the drum slightly forward toWater connection loosen, then pull out from the back.

C Cold water connection and H Hot water connection

(max. 140°F / 60°C)

qPlastic threads must only be tightened by hand when connecting the water supply hoses to the back of the unit. Do not remove the strainers from the water supply hoses.

qIf the bushings do not come out Water supply when removing the bolts, place the

bolts back into the bushings and									ATTENTION
carefully		try	again.	It	is important
do	this	with	the	bolts,	otherwise		the				be
								The washing machine must only
bushings		will	not	come	out	properly.operated				with cold and hot (max.
q To	store	the bolts for			future	use,		140 °F / 60 °C) tap water. Do			not
								do		the appliance to the mixer
not	remove		the bolts from the					connect
								tap of an unpressurized hotuwater
plastic bushings.
								boiler.
								If in doubt, have the water connection
								installed by an authorized technician.
								The	water	supply hoses must not be:
							-		Bent	or flattened.

min.0,4'' (10 mm)

-Modified or cut (integrity can no longer be guaranteed).

	Observe the water pressure in the
	supply		network:
	- The		water		pressure		should be
q Insert the covers until they snap in		between		14.5 and			145 p.s.i.
completely.
		(1 and 10			bars)	when		the	tap
		is turned		on, at		least		2.2	U. S.
		gallons (8 liters) of water should
		discharged			per	minute.

qAfter connecting, turn on the water completely, and check that connection points are watertight.

dCAUTION

-A pressure regulator valve must be The connection points are under full

installed if the maximum water water pressure. Check seal with tap

pressure is exceeded.fully open.

8