Advantech INTRAC-305 user manual

2

INTRAC-305 SPECIFICATION & OPTIONS

firmware change and required the EPROM on the interface card to be changed.

Mount Type	Two types of antenna mount may be used with the INTRAC.
	An Az/El mount or a Polar mount. The appropriate one is
	selected in “Fitted Options” as AZ/El or Hr-Ang/Declination.
Resolver Type	The INTRAC-305 is intended for use with standard Andrew
	resolvers, either x2 or x1 versions. Normally the INTRAC-305
	is to replace an Andrew APC300 and the antenna will have
	been fitted with x2 resolvers. Refer to the earlier specification
	section. This is a user configuration option.
Stow Option	There is provision in the INTRAC-305 configuration for Az/El
	preliminary and final stow positions to be set.
	The “Stow” command causes the antenna to be driven to the
	preliminary position in both axes. Once at this position the
	antenna is driven to the final position.
	The “Unstow” command causes the pin(s) to be removed
	(where appropriate) and the antenna driven to the preliminary
	position.
	The preliminary and/or final positions can be set to “not-
	used” for one or both axes.
Dual Redundant PSU	The INTRAC-305 can be supplied with dual redundant power
	supplies. In this option the single PSU is replaced by two
	indepenent PSUs and associated combining hardware.
	Independent switched power inlets are provided and the
	front panel power switch is replaced by status LEDs. The
	INTRAC-305 will operate normally when either or both PSUs
	are operational. This option must be requiested at time of
	initial order

© 2011 Advantech Wireless. INTRAC-305 MANUAL - Issue 3.2 Page 5