GE GFWR4800, GHWS3605 Location of Your Washer, ROUGH-IN Dimensions, Do Not Install the Washer

Installation Instructions

LOCATION OF YOUR WASHER

Do Not Install the Washer:

1.In an area exposed to dripping water or outside weather conditions. The ambient temperature should never be below 60°F (15.6°C) for proper washer operation.

2.In an area where it will come in contact with curtains or drapes.

3.On carpet. The floor MUST be a hard surface with a maximum slope of 1/2σ per foot (1.27 cm per

30 cm). To make sure the washer does not vibrate or move, you may have to reinforce the floor.

NOTE: If floor is in poor condition, use 3/4σ impregnated plywood sheet solidly attached to existing floor covering.

IMPORTANT:

Minimum Installation Clearances

•When installed in alcove: Sides, Rear, Top = 0σ (0 cm)

•When installed in closet: Sides, Rear, Top = 0σ (0 cm), Front = 1σ (2.54 cm)

•Closet door ventilation openings required:

2 louvers each 60 square in. (387 cm), located 3σ (7.6 cm) from top and bottom of door

ROUGH-IN DIMENSIONS

FRONT

28”

(71.12cm)

39”*

(99cm)

SIDE

35”

(88.9cm)

39”*

(99cm)

*NOTE:

With Legs: 40 1/2” (102.5 cm) - (3/4” (1.9 cm) adjustability)

With Built-In Riser™: 46” (116.9 cm) - (3/4” (1.9 cm) adjustability)

With Optional Pedestal (GFXP1308): 52” (132.1 cm) - (3/4” (1.9 cm)

adjustability)

Stacked: 78 1/4” (198.8 cm)

19