Installation Instructions
ADAPTIVE VIBRATION CONTROL
Your GE washer is equipped with Adaptive Vibration Control Technology. Using information about the floor, this system can reduce vibration and improve spin performance in some installations by adapting the spin cycle. The DEFAULT configuration is specially designed to provide optimal performance across the widest range of floor types. Follow the procedure below to enable more specific adaptive settings. Your washer can be returned quickly and easily to the DEFAULT configuration at any time using the same procedure.
Floor Type Selection
1.Place control in the idle state. (Make sure no cycles or options are selected but that the washers Power is on.)
2.Press and hold the Power and Spin buttons at the same time for 3 seconds.
3.Only the Power, Start and display lights will be lit in this mode.
4.Pressing the Power button in this mode will return the control to the idle state and the defaults will be restored.
5.Rotate the selector knob to select the Floor Type, per the following table.
Display | Floor Type |
F0 | Default |
F1 | Concrete Floor |
F2 | Second Floor, all surface types |
F3 | First Floor, Tile Surface |
F4 | First Floor, Linoleum surface |
F5 | First Floor, wood surface |
6. Press the Start button to make selection.
oFor GE RightHeight Design™ frontload washers with a
oFor all other models (GFWS2500, GFWS2505, GFWS2600, GFWS2605, GHWS3600, GHWS3605, GFWS3700 and GFWS3705) – proceed to the pedestal selection (steps
7.Rotate the selector knob to select the Pedestal Type, per the following table.
Display | Pedestal Type |
P0 | No Pedestal (Default setting) |
P1 | Pedestal |
8.Press the Start button to make selection.
9.Exit the Pedestal Type selection mode and return to the idle state after the Start button is pressed.
24