GEAppliances.com
18
Add Steam
Add Steam adds steam into the washer early in the cycle to assist with loosening stains on the Towels/Sheets, Normal, Whites, Bulky, Active Wear, Power Clean, Sanitize or Allergen cycles.
To use:
1.Turn power ON and select a wash cycle. The Add Steam option is only available on Towels/Sheets, Normal, Whites, Bulky, Active Wear, Power Clean, Sanitize or Allergen cycles.
2.Select the Add Steam button to activate steam.
3.Press the Start/Pause button.
19
Delay Wash
You can delay the start of a wash cycle for up to 24 hours. Press the Delay Wash button to choose the amount of time you want to delay the start of the wash cycle. Once the desired time is reached, press the Start button. The machine will count down and start automatically at the correct time.
NOTE: If you forget to fully close the door, a reminder signal will beep reminding you to do so.
NOTE: If you open the door when the delay is counting down, the machine will enter the pause state. You must close the door and press Start again in order to restart the countdown.
20
eMonitor (on some models)
The eMonitor lights display the relative energy use of your selected cycle and options. They are provided as an energy guide and range from Good (1 light) to Better (5 lights). Some special cycles will not provide a display.
21
Display
Displays the approximate time remaining until the end of the cycle.
NOTE: The cycle time is affected by how long it takes the washer to fill. This depends on the water pressure in your home. The “smart” timer “learns” the amount of time it takes to fill your washer and adjusts the total time accordingly.
Cycle status is also displayed and certain features such as Delay Wash or Steam are shown indicating they have been selected.
9