STORING THE CLOTHES WASHER
Washers can be damaged if water is not removed from hoses and internal components before storage. Prepare the washer for storage as follows:
• Select the cotton/sturdy and quick setting and add one cup of bleach to the detergent dispenser without clothes in the tumbler. Run the clothes washer through a complete cycle.
•Turn the water faucets off and disconnect the inlet hoses.
•Disconnect the clothes washer from the electrical supply and leave the washer door open to let air circulate inside the tumbler.
•If the washer has been stored in
For information on
call Maytag Customer Assistance
REVERSE THE DOOR
Clothes washer door swing direction can be changed using the following procedure:
1) Swing door fully open and support it while removing four hinge screws (which hold hinges to door assembly).
2) Move the door to a work surface and transfer four door screws to the opposite side of the door assembly.
3) Remove one screw holding top hinge to cabinet and one screw holding top hinge cover to cabinet (opposite side).
4) Remove hinge and bracket from cabinet by moving them up and down to a position where they are released.
5) Install hinge and bracket in swapped locations and drive screws to attach them securely to the cabinet.
6) Compare top hinge and top bracket to bottom hinge and bottom bracket for correct hinge assembly position.
7) Repeat procedures 4 through 6 for bottom hinge to cabinet and bottom bracket to cabinet.
8) Support door in fully open position on hinge side and drive four screws to securely attach hinges to door assembly.
9) Close door and check to see that clothes washer operates properly.
9