DeWalt DCR018 Components FIG, Operation, Installing and Removing the Battery Pack Fig

Page 10

English

COMPONENTS (FIG. 2)

A. ON/OFF button

F. Mode button

B. Volume knob

G. Clock button

C. Antenna

H. Preset button

D. Hang holes

I. LCD display

E. Seek/tuner/arrow buttons

 

FIG. 2

C

 

D

B

I

 

A

To install the battery pack (J), insert the slide pack or tower stem into battery receptical until the battery pack is firmly seated. For the stem pack, be sure that the battery latches are engaged. Refer to Figure 3.

To remove battery pack from the radio, firmly pull up or out depending on the battery type. For the stem pack, press the battery release buttons before pulling firmly. Insert it into the charger as described in the charger section of this manual.

FIG. 3

J

E

OPERATION

E

GF

H

FUEL GAUGE BATTERY PACKS (FIG. 4)

 

 

 

Some DEWALT battery packs include a fuel

 

 

 

 

 

FIG. 4

 

 

K

gauge which consists of three green LED lights

 

 

 

 

 

 

 

 

 

 

that indicate the level of charge remaining in

 

 

 

 

 

 

the battery pack.

 

 

 

WARNING: To reduce the risk of injury, turn unit off and disconnect it from power source before installing and removing accessories, before adjusting or when making repairs.

Installing and Removing the Battery Pack (Fig. 3)

NOTE: For best results, make sure your battery pack is fully charged.

8

To actuate the fuel gauge, press and hold the fuel gauge button (K). A combination

of the three green LED lights will illuminate

designating the level of charge left. When the level of charge in the battery is below the usable limit, the fuel gauge will not illuminate and the battery will need to be recharged.

NOTE: The fuel gauge is only an indication of the charge left on the battery pack. It does not indicate unit functionality and is subject to variation based on product components, temperature and end-user application.

Page 9 Page 11
Image 10
Page 9 Page 11
Contents DCR018 Page Important Safety Instructions Definitions Safety GuidelinesDCR018 Heavy-Duty Compact Work Site Radio Regulatory Notices Important Safety Instructions for All Battery Packs Read ALL InstructionsImportant Safety Instructions for All Battery Chargers Rbrc SealNever attempt to connect 2 chargers together Charge Indicators Charging Procedure FigIndicator Light Operation ChargersStorage Recommendations Important Charging NotesFor Future USE Components FIG Installing and Removing the Battery Pack FigFuel Gauge Battery Packs FIG OperationMode Function FIG To Install Coin Cell Battery FIGPOWER/VOLUME Adjustment FIG Tune or Seek Function FIGDevice Storage Box Fig Important Radio NotesThree Year Limited Warranty MaintenanceCleaning Accessories Repairs Register OnlineDewalt Battery Packs Year Free ServiceYears Free Service on Dewalt Battery Packs DAY Money Back GuaranteeRadio industrielle compacte de chantier DCR018 Définitions lignes directrices en Matière de sécuritéConsignes de sécurité importantes Normes Lire Toutes LES Consignes Toutefois, si le joint d’étanchéité extérieur est rompu Le sceau Srprcmc Conserver CES InstructionsAmpères Procédure de charge Fig Fonctionnement du voyantChargeurs Voyants de chargeRemarques importantes concernant le chargement Laisser LE BLOC-PILES Dans LE ChargeurInstallation et retrait du bloc-piles Fig Recommandations de stockageUtilisation Pour Installer UNE Pile Bouton FIG Témoin DE Charge DU BLOC-PILES FIGFonction DE Syntonisation OU DE Recherche FIG Réglage DE MARCHE/ARRÊT ET DU Volume FIGFonction DU Mode FIG Programmation DE L’HORLOGE FIGBoîtier de rangement Fig AccessoiresRemarques importantes relatives à la radio NettoyageGarantie limitée de trois ans RéparationsRegistre en ligne Contrat D’ENTRETIEN Gratuit D’UN ANBLOCS-PILES Dewalt Garantie DE Remboursement DE 90 JoursDefiniciones Normas de seguridad Instrucciones de seguridad importantesNotificaciones regulatorias LEA Todas LAS Instrucciones El sello Rbrc Sin embargo, si el sello externo está rotoGuarde Estas Instrucciones Cargadores Procedimiento de carga FigRetardo POR Unidad CALIENTE/FRÍA Operación de la luz indicadora Indicadores de cargaNotas importantes sobre la carga Permanencia DE LA Unidad DE Batería EN EL CargadorRecomendaciones de almacenamiento Cómo instalar y retirar la unidad de batería Fig OperaciónUnidades DE Batería CON Indicador DE Carga FIG Función DE Modo FIG ENCENDIDO/APAGADO Y Ajuste DE Volumen FIGPara Instalar LA Batería DE Botón FIG Función DE Sintonía O Búsqueda FIGCaja de almacenamiento de dispositivos Fig Para Programar EL Reloj FIGNotas importantes sobre la radio LimpiezaAccesorios MantenimientoPóliza de Garantía Excepciones Registro en líneaGarantía limitada por tres años AÑO DE Servicio GratuitoUnidades DE Batería Dewalt Copyright 2013 D Ewalt
Top Page Image Contents