DeWalt DCR018 instruction manual Important Charging Notes, Storage Recommendations, For Future USE

Page 9

Important Charging Notes

1.Longest life and best performance can be obtained if the battery pack is charged when the air temperature is between 65 °F and 75 °F (18° – 24 °C). DO NOT charge the battery pack in an air temperature below +40 °F (+4.5 °C), or above +105 °F (+40.5 °C). This is important and will prevent serious damage to the battery pack.

2.The charger and battery pack may become warm to the touch while charging. This is a normal condition, and does not indicate a problem. To facilitate the cooling of the battery pack after use, avoid placing the charger or battery pack in a warm environment such as in a metal shed or an uninsulated trailer.

3.A cold battery pack will charge at about half the rate of a warm battery pack. The battery pack will charge at that slower rate throughout the entire charging cycle and will not return to maximum charge rate even if the battery pack warms.

4.If the battery pack does not charge properly:

a.Check operation of receptacle by plugging in a lamp or other appliance;

b.Check to see if receptacle is connected to a light switch which turns power off when you turn out the lights;

c.Move the charger and battery pack to a location where the surrounding air temperature is approximately 65 °F – 75 °F (18° – 24 °C);

d.If charging problems persist, take the radio, battery pack and charger to your local service center.

5.The battery pack should be recharged when it fails to produce sufficient power on jobs which were easily done previously. DO NOT CONTINUE to use under these conditions. Follow the charging procedure. You may also charge a partially used pack whenever you desire with no adverse effect on the battery pack.

6.Foreign materials of a conductive nature such as, but not limited to, grinding dust, metal chips, steel wool, aluminum foil, or any buildup of metallic particles should be kept away from charger cavities. Always unplug the charger from the power supply when there is no battery pack in the cavity. Unplug the charger before attempting to clean.

7.Do not freeze or immerse the charger in water or any other liquid. WARNING: Shock hazard. Don’t allow any liquid to get inside the charger. Electric shock may result.

WARNING: Burn hazard. Do not submerge the battery pack in any liquid or allow any liquid to enter the battery pack. Never attempt to open the battery pack for any reason. If the plastic housing of the battery pack breaks or cracks, return to a service center for recycling.

Storage Recommendations

1.The best storage place is one that is cool and dry, away from direct sunlight and excess heat or cold.

2.For long storage, it is recommended to store a fully charged battery pack in a cool dry place out of the charger for optimal results.

NOTE: Battery packs should not be stored completely depleted of charge. The battery pack will need to be recharged before use.

SAVE THESE INSTRUCTIONS

FOR FUTURE USE

English

7

Image 9
Contents DCR018 Page Definitions Safety Guidelines Important Safety InstructionsDCR018 Heavy-Duty Compact Work Site Radio Regulatory Notices Read ALL Instructions Important Safety Instructions for All Battery PacksRbrc Seal Important Safety Instructions for All Battery ChargersNever attempt to connect 2 chargers together Indicator Light Operation Charging Procedure FigCharge Indicators ChargersImportant Charging Notes Storage RecommendationsFor Future USE Fuel Gauge Battery Packs FIG Installing and Removing the Battery Pack FigComponents FIG OperationPOWER/VOLUME Adjustment FIG To Install Coin Cell Battery FIGMode Function FIG Tune or Seek Function FIGImportant Radio Notes Device Storage Box FigCleaning Accessories Repairs MaintenanceThree Year Limited Warranty Register OnlineYears Free Service on Dewalt Battery Packs Year Free ServiceDewalt Battery Packs DAY Money Back GuaranteeDéfinitions lignes directrices en Matière de sécurité Radio industrielle compacte de chantier DCR018Consignes de sécurité importantes Normes Lire Toutes LES Consignes Toutefois, si le joint d’étanchéité extérieur est rompu Conserver CES Instructions Le sceau SrprcmcAmpères Chargeurs Fonctionnement du voyantProcédure de charge Fig Voyants de chargeLaisser LE BLOC-PILES Dans LE Chargeur Remarques importantes concernant le chargementRecommandations de stockage Installation et retrait du bloc-piles FigUtilisation Témoin DE Charge DU BLOC-PILES FIG Pour Installer UNE Pile Bouton FIGFonction DU Mode FIG Réglage DE MARCHE/ARRÊT ET DU Volume FIGFonction DE Syntonisation OU DE Recherche FIG Programmation DE L’HORLOGE FIGRemarques importantes relatives à la radio AccessoiresBoîtier de rangement Fig NettoyageRegistre en ligne RéparationsGarantie limitée de trois ans Contrat D’ENTRETIEN Gratuit D’UN ANGarantie DE Remboursement DE 90 Jours BLOCS-PILES DewaltInstrucciones de seguridad importantes Definiciones Normas de seguridadNotificaciones regulatorias LEA Todas LAS Instrucciones Sin embargo, si el sello externo está roto El sello RbrcGuarde Estas Instrucciones Procedimiento de carga Fig CargadoresNotas importantes sobre la carga Operación de la luz indicadora Indicadores de cargaRetardo POR Unidad CALIENTE/FRÍA Permanencia DE LA Unidad DE Batería EN EL CargadorRecomendaciones de almacenamiento Operación Cómo instalar y retirar la unidad de batería FigUnidades DE Batería CON Indicador DE Carga FIG Para Instalar LA Batería DE Botón FIG ENCENDIDO/APAGADO Y Ajuste DE Volumen FIGFunción DE Modo FIG Función DE Sintonía O Búsqueda FIGPara Programar EL Reloj FIG Caja de almacenamiento de dispositivos FigAccesorios LimpiezaNotas importantes sobre la radio MantenimientoPóliza de Garantía Garantía limitada por tres años Registro en líneaExcepciones AÑO DE Servicio GratuitoUnidades DE Batería Dewalt Copyright 2013 D Ewalt