| Section |
Operating this unit | 02 |
|
|
Adjusting source levels
SLA (source level adjustment) lets you adjust the volume level of each source to prevent ra- dical changes in volume when switching be- tween sources.
!Settings are based on the FM volume level, which remains unchanged.
!The MW/LW volume level can also be ad- justed with source level adjustments.
1Compare the FM volume level with the level of the source you wish to adjust.
2Press AUDIO to select SLA.
3Press a or b to adjust the source vo- lume.
SLA +4 to SLA
volume is increased or decreased.
# To return to the normal display, press BAND.
Setting the FM tuning step
Normally the FM tuning step employed by seek tuning is 50 kHz. When AF or TA is on, the tuning step automatically changes to 100 kHz. It may be preferable to set the tuning step to 50 kHz when AF is on.
!The tuning step remains at 50 kHz during manual tuning.
1Press FUNCTION to select FM.
2Press c or d to select the FM tuning step.
Press c to select 50 (50 kHz). Press d to se- lect 100 (100 kHz).
Switching Auto PI Seek
The unit can automatically search for a differ- ent station with the same programming, even during preset recall.
1 Press FUNCTION to select
English
Other Functions
Adjusting initial settings
Using the initial settings, you can customize various system settings to achieve optimal per- formance from this unit.
1Press SOURCE and hold until the unit turns off.
2Press SOURCE and hold until function name appears in the display.
3Press FUNCTION to select one of the in- itial settings.
Press FUNCTION repeatedly to switch be- tween the following settings:
FM (FM tuning
particular setting.
# To cancel initial settings, press BAND.
# You can also cancel initial settings by holding down SOURCE until the unit turns off.
2Press a or b to turn the Auto PI seek on or off.
Switching the auxiliary setting
It is possible to use auxiliary equipment with this unit. Activate the auxiliary setting when using auxiliary equipment connected to this unit.
1Press FUNCTION to select AUX.
2Press a or b to turn the auxiliary set- ting on or off.
Saving the battery consumption
Switching this function on enables you to save the consumption of battery power.
!Operations other than turning on the source are not allowed when this function is on.
En 
11