Front Panel Features

1.DJ Mic 1: This section has the gain and tone controls for the ¼”/XLR combination mic input.

2.Mic 2: This section has the gain and tone controls for Mic 2

3.Mic 3: This section has the gain and tone controls for Mic 3

4.Mic 2&3 Echo: This knob controls the echo effect amount on microphones 2 and 3.

5.Mic 2&3 Delay: This knob controls the delay time of the echo effect on microphones 2 and 3

6.Line Faders: Control volume levels in the mix.

7.Master Fader - Controls the overall output level.

8.Input toggle switch - Selects which source will be live to that channel based on what you have connected to the rear panel input section

9.Replaceable Crossfader - This slide fader blends audio between channels 1 and 2. This also switches the video when using compatible karaoke CD+G CDs.

Note: The crossfader is user replaceable in case of failure. Simply unscrew the two large screws which hold it in place, lift it out and disconnect it’s cable. Re- attach the new crossfader and screw the mounting plate back onto the unit - you’re back in business!

10.Fader Start – Activation allows you to start the CD players from you crossfader. Travel from left to right will start the right CD player and pause the left CD player

11.Key Change On/Off – Pressing this button turns the Key Change function on and off.

12.Key – This knob allows you to adjust the key of the music. Rotating to the left will result in a lower key (flat), while rotating to the right will result in a higher key (sharp).

13.LED METER - Indicates the Master output level.

14.Stereo/Mono toggle - Changes the Master output between Mono and Stereo

15.Master EQ Bass

16.Master EQ Middle

17.Master EQ Treble

18.Channel Cue Selector - Used to route channel audio to your headphones.

19.Headphone Level – Adjusts cue volume.

20.Headphone Jacks – Used to connect either 1/8” or 1/4” plugs for audio monitoring with headphones.