AUX Send, Stereo Return, Sub Out, Sub Insert

4950

54 51

49. AUX Send

Output jack of the corresponding AUX mix. It is unbalanced, and can be used to feed an external monitor system or effect unit. The level is set by the AUX Master Level (#26) and the individual channel level control (see #10, 11).

50. Stereo Return

High impedance input for line level signals. The left/mono input supplies signal to both the left and right inputs if there is no input connected to the right input jack.

51. Sub Out

Output of the corresponding sub mix. It is unbalanced, with its output level set by the sub fader (#35).

52. Sub Insert

1/4" stereo (TRS) jack which allows an external device to be inserted into the signal path before the

sub fader. The tip has the send signal, the ring is the return input. A switch in the jack normally connects the send to the return until a plug is inserted. The nominal level is -2 dBu.

53. Talkback Mic Input

Input connector for a low-impedance, balanced microphone used for house or stage communication. Pin 2 is the positive input. Phantom power is not available at this connector.

54. Headphone Output

This stereo jack (TRS) provides the signal to drive stereo headphones. It changes from the L-R mix to the PFL mix when the PFL is active. The level is set by the Headphone/Control Room Level Control (#48). Tip=Left, Ring=Right, Shield=Ground.

55. Control Room Output

1/4" left and right unbalanced outputs of the headphone mix to feed the control room monitor amps. The signal is exactly the same as that in the headphones.

56. Main Output

1/4" unbalanced and XLR balanced outputs of the Left and Right mixes. The level is set by the master left and right right faders (#36).

57. Main Insert

1/4" stereo (TRS) jack which allows an external device to be inserted into the signal path before the Master L/R Fader. The tip has the send signal, the ring is the return input. A switch in the jack normally

connects the send to the return until a plug is inserted.

The nominal level is -2 dBu.

58. Balanced Mono Output

An XLR balanced output of the mono mix. The level is set by the Mono Level control (#59). Pin 2 is the positive output.

59. Mono Level

Adjusts the level of the Balanced Mono Output (#58). The signal is a post fader sum of the left and right output signals. The center position is the unity gain setting; 7 dB of gain boost is available.

Page 9