Omron HBP-1300 specifications Manufacturers Declaration, Electromagnetic Immunity IEC60601-1-2

Manufacturer's Declaration

The HBP-1300 is intended for use in the electromagnetic environment specified below.

The customer or the user of the HBP-1300 should assure that it is used in such an environment.

Electromagnetic Emissions: (IEC60601-1-2)

Emission Test		Compliance	Electromagnetic Environment
RF emission		Group 1	The HBP-1300 uses RF energy only for internal functions.
CISPR 11			Therefore, this RF emission is extremely weak and there is
			little chance of it creating any kind of interference
			whatsoever with nearby electronic equipment.
RF emissions		Class B	The HBP-1300 is suitable for use in all establishments,
CISPR 11			including domestic establishments and those directly
			connected to the public low voltage power supply network
Harmonic emissions		Class A
			that supplies buildings used for domestic purposes.
IEC 61000-3-2
Voltage fluctuations/flicker		Complies
IEC 61000-3-3
Electromagnetic Immunity:
(IEC60601-1-2)
Immunity test	IEC60601-1-2		Compliance level	Electromagnetic
	test level			environment - guidance
Electrostatic discharge	±6 kV contact		±6 kV contact	Floors should be wood, concrete or
(ESD)	±8 kV air		±8 kV air	ceramic tile. If floors are covered with
IEC 61000-4-2				synthetic material, the relative
				humidity should be at least 30 %.
Electric fast transient/	±2 kV for		±2 kV for	Mains power quality should be that of
burst	power supply lines		power supply lines	a typical commercial or hospital
IEC 61000-4-4	±1 kV for		±1 kV for	environment.
	input/output lines		input/output lines
Surge	±1 kV		±1 kV	Mains power quality should be that of
IEC 61000-4-5	differential mode		differential mode	a typical commercial or hospital
	±2 kV		±2 kV	environment.
	common mode		common mode
Voltage dips, short	<5 % UT		<5 % UT	Mains power quality should be that of
interruptions and	for 0.5 cycle		for 0.5 cycle	a typical commercial or hospital
voltage variations on				environment. If the user of the HBP-
	40 % UT		40 % UT
power supply input lines				1300 requires continued operation
IEC 61000-4-11	for 5 cycles		for 5 cycles	during power mains interruptions, it is
	70 % UT		70 % UT	recommended that the HBP-1300 be
	for 25 cycles		for 25 cycles	powered from an uninterruptible
				power supply or a battery.
	<5 % UT		<5 % UT
	for 5 sec.		for 5 sec.
Power frequency	3 A/m		3 A/m	Power frequency magnetic fields
					Specifications
(50/ 60 Hz) magnetic				should be at levels characteristic of a
field				typical location in a typical commercial
IEC 61000-4-8				or hospital environment.
Note: UT is the a.c. mains voltage prior to application of the test level.

33