SAFETY INSPECTION | PROCEDURE 2 |
|
|
MAINTENANCE
MAINTENANCE SAFETY PRECAUTIONS
WARNING
After making adjustments, always make sure that parts are properly tightened BEFORE using the wheelchair.
CAUTION
DO NOT overtighten hardware attaching to the frame. This could cause damage to the frame tubing.
SUGGESTED MAINTENANCE PROCEDURES
1.Before using your Invacare Top End wheelchair, make sure all nuts and bolts are tight. Check all parts for damage or wear and replace. Check all parts for proper adjustment.
2.Keep
WARNING
DO NOT use
3. Clean
WARNING
DO NOT use the wheelchair unless it has the proper tire pressure (p.s.i.). DO NOT overinflate the tires. Failure to follow these suggestions may cause the tire to explode and cause bodily harm.
4.Recommended tire pressure is listed on the side wall of the tire.
5.The wheels and tires should be checked periodically for cracks and wear, and should be replaced by a qualified technician.
6.Regularly check for loose spokes in the rear wheels. If loose, have them adjusted by a qualified technician.
7.Periodically check handrims to ensure they are secured to the rear wheels. Refer to HANDRIM REPLACEMENT in PROCEDURE 6 of this manual.
8.Periodically adjust wheel locks as tires wear. Refer to WHEEL LOCK ADJUSTMENT in PROCEDURE 6 of this manual.
9.Periodically check caster wheel bearings to make sure they are clean and free from moisture. Use a Teflon lubricant if necessary.
10.Check upholstery for sagging, rips or tears.
SAFETY INSPECTION
Part No. 1054916 | 21 |