Invacare Top End T-3 manual Or 6/12 Camber Inserts, Or 12 Camber

WHEELS

PROCEDURE 6 WHEELS

Axle Tube Positioning For 0°/9°, 0°/12°, 3°/9°, 6°/9° , 3°/12° Or 6°/12° Camber Inserts (FIGURE 9).

1.Open the camber clamps. Refer to OPENING/CLOSING CLAMPS in this procedure of the manual.

2.Slowly rotate the axle tube until the stop on the opposite toe adjustment ring is positioned at the opposite end of the frame bracket (approximately 1/8-inch).

WARNING

QUICK RELEASE LEVERS - Make sure the quick release levers are pointing towards the rear of the wheelchair and are in the CLOSED position BEFORE using the wheelchair, otherwise personal injury or damage to the wheelchair may result.

STANDARD - Make sure the hex screws and locknuts are securely tightened BEFORE using the wheelchair, otherwise personal injury or damage to the wheelchair may result.

3.Close the camber clamps. Refer to OPENING/CLOSING CLAMPS in this procedure of the manual.

AXLE TUBE POSITIONING FOR 0°/9°, 0°/12°, 3°/9°, 3°/12°, 6°/9°

OR 6°/12° CAMBER INSERTS

0°, 3° OR 6° CAMBER

Frame

Frame

9° OR 12° CAMBER

Bracket

Toe Adjustment

Ring

Axle Tube - Will	Frame
Rotate UP Only	Bracket

Toe Adjustment

Ring

Bracket

Toe Adjustment

Ring

Axle Tube - Will

Rotate DOWN Only

Frame

Toe Adjustment Bracket

Ring

FIGURE 9 - ADJUSTING TOE IN/TOE OUT - DEGREE OF CAMBER HAS

BEEN CHANGED

T-3™ and T-4™ Series 38 Part No. 1054916