Invacare Top End T-3 manual Rear Seat Height Adjustment, Rear Seat to Floor Range in Inches

Spreader Bar

SEAT PROCEDURE 4

REAR SEAT HEIGHT ADJUSTMENT

NOTE: This procedure is for T-3 Elite models with rear seat height adjustment and T-3 Adjustable models ONLY.

WARNING

The position of the footrest, camber tube, seat height, the tautness of the back upholstery, as well as the user's condition are directly related to the chair's stability. Any change to one (1) or any combination of the five (5) may cause the chair to decrease in stability. Use EXTREME caution when using a new seating position.

Before 2001 (FIGURE 2)

1.Loosen, but do not remove the front set screws.

2.Remove the set screws at the rear of the seat rails.

WARNING

Ensure that both seat rails are aligned in the correct mounting holes for proper and even seat alignment. A fall and possible injury could occur.

3.Move the rear of the seat rails up or down into one of the five (5) adjustment positions.

*REAR SEAT TO FLOOR RANGE (IN INCHES)

™HOLE #	1	2	3	4	5
*HEIGHT	13	14	15	16	17
				5
	HOLE NUMBER			4	Seat Rail
				3
				2	Rear Set Screw
				1
					Chair Frame

FIGURE 2 - REAR SEAT HEIGHT ADJUSTMENT - BEFORE 2001

After 2000 (FIGURE 3)

SEAT

1.Loosen the locknut at the front of the seat.

2.Loosen both spreader bar screws.

3.Loosen both seat angle screws.

4.Adjust the spreader bar to the desired position.

5.Tighten the seat angle screws, spreader bar screws and the locknut at the front of the seat.

Seat Angle Screw

Locknut

Spreader

Bar Screw

FIGURE 3 - REAR SEAT HEIGHT

ADJUSTMENT - AFTER 2000

Part No. 1054916 27 T-3™ and T-4™ Series