Centurion CP72SR5 installation manual Setting Gate Limits, A5 only

Page 24

37

Fig.1

1/2 1/2

73

Fig.2

SETTING GATE LIMITS

-Rotate manual release thumbwheel 37 fully clockwise, or until clutch is fully dis-engaged and gate can be moved by hand.

D3/D5 ONLY

-Slide gate approximately half way open. See 73 above (FIG. 1).

-Re-engage gearbox.

A5 ONLY

-Slide gate to fully closed position (FIG. 2).

-Leave gearbox dis-engaged.

-Skip to page 25-27 and follow START MANUAL GATE LIMITS ROUTINE.

22

Image 24

Contents Sliding Gate Automation Page Oil Specifications Grade 75W90 Qty 75ml Major Components Typical D5 ShownStart kgF RUN kgF Gate Mass kg 300 500 ANTI-LIFT Brackets Duty Cycle Curves Recommended Installation and Cable Thickness REQUIREMENTS† Mechanical Mounting Details Option 1 Bolt down onto concrete plinthPage Option 2 Set into concrete plinth Provision for Cables Gearbox Mounting Down Details Mounting Rack Useful TIP200mm Installing Chain Drive Systems Setting Mechanical Clutch A5 only Ensure fan has stopped turningMounting Configuration For Steel Rack Mounting of Gate SensorPower Wiring see page 15 for Signal Wiring Removable ConnectorsSignal Wiring CP80 and CP81 Recommended Lightning Protection Commissioning Block Diagram Setting Motor Direction Gate Closes Towards Left Above Black Blue RED Towards RightSelecting Programme Mode Setting Gate Limits A5 onlySetting Gate Limits Start Automated Gate Limits RoutineD3/D5 Motor Automatic SET-UP Exit Gate Limits Routine D3/D5 only Start Manual Gate Limits RoutineAlign Origin Switch A5 Motor Manual SET-UPExit Gate Limits Routine A5 only Functions SelectFactory Defaults Highlighted Timer and Counter Setting Main Unit Menu Measure Procedure to Programme Controller Back to Factory Settings Fault Finders Guide D3 / D5 OperatorsGate Opens to Pedestrian and Closes Page Centurion