Centurion CP72SR5 installation manual A5 Motor Manual SET-UP, Align Origin Switch

Page 28

A5 MOTOR MANUAL SET-UP

STEP 1 ALIGN ORIGIN SWITCH

- Start with gate fully closed.

- Push gate open (origin marker must have moved well past origin switch).

- Push gate closed again.

STEP 2 - ENSURE PCB IS IN PROGRAMME

MODE (refer procedure page 21)

STEP 3 - SET LIMITS

- Press TEST pushbutton until LED L1 flashes once and release.

-L1 will continue to flash once and L2 will go out.

-Press TEST pushbutton until STATUS LED

comes ON and release (check that L1, L2 & STATUS are OFF)

STEP 4

- Push gate to fully “OPEN” position and do not allow gate to reverse.

- Press TEST pushbutton until STATUS LED comes ON and release.

STEP 5

- Push gate to fully “CLOSED” position hard up against endstop and do not allow gate to reverse.

- Press TEST pushbutton until STATUS LED comes ON and release.

 

 

 

 

STEP 6

 

 

 

“PED”

- Push gate to “PEDESTRIAN” open position.

 

 

 

 

 

 

- Press TEST pushbutton until STATUS LED

 

 

 

 

comes ON and release. If STATUS LED

 

 

 

 

does not come ON, increase pedestrian

 

 

 

 

 

 

 

 

opening until it does.

26

Image 28
Contents Sliding Gate Automation Page Oil Specifications Grade 75W90 Qty 75ml Major Components Typical D5 ShownStart kgF RUN kgF Gate Mass kg 300 500 ANTI-LIFT Brackets Duty Cycle Curves Recommended Installation and Cable Thickness REQUIREMENTS† Mechanical Mounting Details Option 1 Bolt down onto concrete plinthPage Option 2 Set into concrete plinth Provision for Cables Gearbox Mounting Down Details Mounting Rack Useful TIP200mm Installing Chain Drive Systems Setting Mechanical Clutch A5 only Ensure fan has stopped turningMounting Configuration For Steel Rack Mounting of Gate SensorPower Wiring see page 15 for Signal Wiring Removable ConnectorsSignal Wiring CP80 and CP81 Recommended Lightning Protection Commissioning Block Diagram Setting Motor Direction Gate Closes Towards Left Above Black Blue RED Towards RightSelecting Programme Mode Setting Gate Limits A5 onlySetting Gate Limits Start Automated Gate Limits RoutineD3/D5 Motor Automatic SET-UP Exit Gate Limits Routine D3/D5 only Start Manual Gate Limits RoutineAlign Origin Switch A5 Motor Manual SET-UPExit Gate Limits Routine A5 only Functions SelectFactory Defaults Highlighted Timer and Counter Setting Main Unit Menu Measure Procedure to Programme Controller Back to Factory Settings Fault Finders Guide D3 / D5 OperatorsGate Opens to Pedestrian and Closes Page Centurion