Centurion CP72SR5 Major Components Typical D5 Shown, Oil Specifications Grade 75W90 Qty 75ml

Page 3

30

31

32

33

34

35

36

37

38

IMPORTANT

Oil Specifications:

GRADE: 75W90

Qty: 75ml

OIL

LEVEL

WARNING! (D5/A5 ONLY)

Fill with oil prior to running

gearbox.

For transport purposes this unit has been supplied with oil in a separate sealed container.

1.Lift off the cover to the operator.

2.Remove the control card and battery so that you can gain access to the filler plug.

3.Unscrew the cap and pour in the oil provided

NB. D3 is pre-filled with

fluid grease.

MAJOR COMPONENTS (TYPICAL D5 SHOWN)

30

31

32 33

34

35

36 37 38

-COVER

-CONTROLLER (CP80 FOR D3/D5; CP81 FOR A5)

-MOTOR (12V DC FOR D3/D5; 220V AC FOR A5)

-BATTERY (12V DC, 7A/H-D3/D5 ONLY) (OR PSU1/2, IF FITTED)

-CHARGER TRANSFORMER/POWER SUPPLY (CP84E for D3/D5 or CP83E for A5) (NOT FITTED WHEN PSU1/2 IS USED).

-GEARBOX CASING

-INTERNAL LIMIT SWITCH (DOSS)

-MANUAL RELEASE THUMBWHEEL

-LOCKABLE ACCESS DOOR

1

Image 3

Contents Sliding Gate Automation Page Major Components Typical D5 Shown Oil Specifications Grade 75W90 Qty 75mlStart kgF RUN kgF Gate Mass kg 300 500 ANTI-LIFT Brackets Duty Cycle Curves Recommended Installation and Cable Thickness REQUIREMENTS† Option 1 Bolt down onto concrete plinth Mechanical Mounting DetailsPage Option 2 Set into concrete plinth Provision for Cables Gearbox Mounting Down Details Useful TIP Mounting Rack200mm Installing Chain Drive Systems Ensure fan has stopped turning Setting Mechanical Clutch A5 onlyMounting of Gate Sensor Mounting Configuration For Steel RackRemovable Connectors Power Wiring see page 15 for Signal WiringSignal Wiring CP80 and CP81 Recommended Lightning Protection Commissioning Block Diagram Gate Closes Towards Left Above Black Blue RED Towards Right Setting Motor DirectionSelecting Programme Mode A5 only Setting Gate LimitsStart Automated Gate Limits Routine Setting Gate LimitsD3/D5 Motor Automatic SET-UP Start Manual Gate Limits Routine Exit Gate Limits Routine D3/D5 onlyA5 Motor Manual SET-UP Align Origin SwitchFunctions Select Exit Gate Limits Routine A5 onlyFactory Defaults Highlighted Timer and Counter Setting Main Unit Menu Measure Fault Finders Guide D3 / D5 Operators Procedure to Programme Controller Back to Factory SettingsGate Opens to Pedestrian and Closes Page Centurion