Health O Meter 2600KL operation manual Preparing the Scale for Use, Replacing Batteries

Page 8

SET UP

Preparing the Scale for Use

1.Remove protective plastic film from keypad and display.

2.Place batteries in the battery holder (see “Replacing Batteries”).

3.Plug the scale’s AC adapter into the power source.

4.Press the ON/OFF button to turn the scale on. The display will show “Health o Meter Pro Plus” and then ”000Lb00oz”.(a)

5.Place a weight [not to exceed 800 Lb (360 Kg)] on the scale. The display should read “WEIGHING“ until the weight calculation is complete and the weight is displayed.

6.Press the KG/LB button to select the weight mode (Lb/Kg).(b) *

7.Press the REWEIGH button; the scale should perform the weighing process again.

8.Remove the weight from the scale, the scale will return to zero and the display will read “ZERO” on the left upper side of the screen along with ”000Lb00oz”.

9.Disconnect the scale’s AC adapter from the power source. The scale will shut off. Press On/Off and the scale will switch to battery power.

NOTE: If the set up procedure failed, refer to the troubleshooting instructions. If the problem is not corrected, refer to qualified service personnel.

(a)To adjust the display backlight and/or contrast, please refer to page 15.

(b)To change the display mode in pounds to fractions or decimals, please refer to page 10.

Replacing Batteries

Figure 5. Replacing Batteries

(refer to the Parts List on page 23 for details on parts followed by # )

1.Unplug the scale.

2.Remove the battery cover from the display assembly.

3.Disconnect battery holder cable connector from the scale-battery connector.

4.Carefully remove the battery holder by sliding it out the display assembly.

5.Replace the batteries with new ones.**

6.Carefully position the battery holder into the display assembly.

7.Plug the battery holder cable connector to the display cable connector.

8.Attach the cover to the display assembly and install the screw.

*To change the scale default units to kilograms, or to deactivate the LB/KG button, please contact Technical Support at 1 800 638-3722 or +1 708 598-9100.

**We recommend the use of EVEREADY Energizer® e2TM batteries.

7

Image 8
Contents PRO Plustm Electronic Folding Wheelchair Scale Table of Contents General SpecificationsScale Specifications Assembly Instructions Assembly Instructions Ramp Moving Instructions SET UP Scale Opening and Folding ProceduresPreparing the Scale for Use Replacing BatteriesOperation Instructions Description Function Only applies to pound values, not the metric values Weight Display ModeMenu Tare Weight Data ManagementAutomatic Tare Removing the TareEnter Scale Settings Operation Instructions System Settings System Test User Settings Operation Instructions Maintenance MaintenanceCleaning Disconnect the scale from the AC power sourceTroubleshooting Symptom Possible Cause Corrective ActionCalibration Path Operator Action DisplayPage Parts List Description QtyWarranty Limited WarrantyWhat does the Warranty Cover? To get Warranty ServiceTable DES Matieres Generalites Precaution ET PreventionSpecifications DE LA Balance Mode Dassemblage Mode Dassemblage Rampe daccès Instructions de retrait Installation Balance Instructions douverture et de pliageRemplacement des piles Préparation de la balance avant usageMode DE Fonctionnement Touche Description Fonction Mode Daffichage DU Poids Menu PrincipalPoids DE LA Tare Gestion DES DonneesTarage Automatique Retrait de la TareMode DE Fonctionnement Reglages DE LA Balance Mode DE Fonctionnement Reglages DU Systeme Test DE Systeme Reglages Utilisateur Mode DE Fonctionnement Nettoyage Déconnectez la balance du secteur CASymptome Cause Possible Action Corrective Localisation DES PannesCalibrage Action réalisée par lopérateur Message affichéPage Liste DES Pieces Pièce N Code Description QuantitéPour obtenir un service de garantie GarantieÍndice Especificaciones DE LA Balanza Precaución Y AdvertenciaEspecificaciones Instrucciones DE Montaje Tapa TraseraInstrucciones DE Montaje Rampa Instrucciones de Movimiento Configuración Balanza Procedimientos de Apertura y PlegamientoPreparando la Balanza para ser Usada Cambiando las BateríasInstrucciones DE Operación Ítem Descripción Función Menú Modo DE Presentación DEL PesoAdministración DE Datos Peso TaraTara Automática Removiendo la TaraCalculando EL BMI Configuraciones DE LA Balanza Instrucciones DE Operación Configuraciones DEL Sistema Prueba DEL Sistema Configuraciones DEL Usuario Instrucciones DE Operación Mantenimiento MantenimientoLimpieza Desconecte la balanza de la fuente de energía CASolución DE Problemas Síntoma Posible Causa Acción CorrectivaTrayectoria DE Calibración Acción del Operador DisplayPage Lista DE Partes No. Llave Parte No Descripción Cd3¿Qué Cubre la Garantía? GarantíaGarantía Limitada